Recent content by Blute

Sorry, sold these last year, and forgot to update my post.

Been awhile, but I still have these, so bumping in case anyone could use them. Same price, $10 plus shipping.

Still have these, price lowered. Hope someone can use them.

Bump, price lowered.

This is a good thread, but wondering for myself... I installed JBA UCAs with my approx. 3.5" lift and have the 7.5" wide stock rims w/ 30mm offset. Thinking about getting some 285s, but I believe this would require wheel spacers to clear the UCAs, so I would likely go with 1.25" spidertrax. So...

Daystar/Cornfed 2"/1" spacer lift removed from my 2006 4Runner. A little discolored but in great condition and will work perfectly. The stud extenders for the Daystar spacers have a little surface corrosion on the outside of the bottom sections but the threads are perfect. The front Daystar...

Thanks all, doesn't sound like these are a good fit for the 3rd gen. I have some spacers I pulled off my 4th gen and was wondering if they would work for a relative's vehicle, but I guess not. I may just try and sell them on the classifieds.

Does anyone know if the Daystar spacer #KT09117BK (1" thick topout spacer) made for the 4th gen will fit a 3rd gen 4runner? It seems like a lot of other spacers from Toytec etc. are cross-compatible, but was wondering about these. Note, if you look up that spacer at the Daystar website, the...

Does anyone know if the Daystar spacer #KT09117BK (1" thick topout spacer) made for the 4th gen will fit a 3rd gen 4runner? It seems like a lot of other spacers from Toytec etc. are cross-compatible, but was wondering about these. Note, if you look up that spacer at the Daystar website, the...

Yep, ride is great. No rubbing, either. I did have one issue after the install, I was getting an occasional creak/pop noise when turning at full lock. Did a little research, and turns out it was the steering stops grinding against each other. I guess with the lift they were hitting at a...

Hey can you confirm the part numbers on those Moog springs? At RockAuto it shows #81041 for the rears. Thanks!

Eibach Pro-Truck/Wheeler's T1/T12 lift installed New lift installed! Tore out the XREAS and the old 2/1 spacer lift and replaced it with Eibach Pro-Truck shocks and Wheeler's T1/T12 coils. I had Wheeler's pre-assemble the front coilovers (bottom perch); their price for the assembled Eibach...

My 06 sport has 30mm front, and 21mm rear: https://www.toyota-4runner.org/3711749-post311.html Read through that whole thread, lots of good info and options. You'll probably want to measure your bar diameters to confirm the size.

Thanks all for the replies. Sounds like consensus is that freeing up the seized alignment bolts likely won't affect the ride height. I think I'll hold off on replacing the bolts and LCAs for now, but will keep it on my radar for the future. And thanks y=mx+b for your LCA write-up, I've looked...

Just another data point, I bought these from eBay for $16.50 for a complete set with fasteners. They fit perfectly and seem to be of good quality. Splash Guard Fender Liner Shield for Lexus GX460 GX470 Toyota 4Runner FJ-Cruiser | eBay