Recent content by bokehshooter

I routed then to the fuse box inside. Used the Tail and IGN#2. Pink is just capped off for now.

Full write up here guys: https://www.toyota-4runner.org/3499779-post1.html

Full write up here guys: https://www.toyota-4runner.org/3499779-post1.html

Full write up here guys: https://www.toyota-4runner.org/3499779-post1.html

Hey all! If you have a 2020 4Runner and have been looking for a mount tray solution for your Switch Pro 9100, SD Offroad MT has come up with a great solution. I needed one myself and assisted them with some measurements to help get one made, and am very happy with the final product. Just wanted...

Just message Derek via IG or here on the forums (he posted right above you) to purchase. The photo he posted is of my install. I will be helping a buddy install one today and will take photos and a write up in a separate thread.

Toyota Safety Sense- new sensor on the 2020's for adaptive cruise control, collision prevention etc.

As recommended, I am trying to use some 12 gauge wires for the S8 but unfortunately the weatherpack it comes with, looks like will only fit a 14-16 gauge wire. I guess I will need to buy a different 3 pin weatherpack connector for 10-12 gauge?

Thanks for the info! I also called you guys and you were extremely helpful with my questions so much appreciated!

Thanks! I did order a weather pack crimper so will make sure it's done right. I ended up cutting the harness for the ditch lights but I think I will use the weather connectors for the S2 lights that I will be running for chase and side lighting since I would need to extend the harness anyways...

Hey all! I have a SP 9100 already installed and will be working on wiring in some BD lights next. The Squadrons and S2s both come with a harness. My question to you all is did you all use the included wiring harness (at cut off the relay and switch) or did you use the included weatherpack...

I haven't drilled any holes. Currently using the existing ones used for the mounting feet.

I've been trying to figure out the same thing. Looks so much cleaner flush mounted but I also want to be able to angle them downwards. This is how I have mine setup atm.

Your design for the flush mounted S2's looks great! Sent you a PM

This is perfect info. Thanks Greg. My BD light bar sits right at about where your Rigid does with the mounts not protruding in between the cutout so it sits right behind. I am glad to hear you have no wind noise so I will keep mine as is and try it out. Again, greatly appreciate the feedback and...