Recent content by boma23

Thread revival! It'd be great to see that vid if it got finiished? Im on cusp of ordering built 5.29s from ECGS after a very informative chat with Stephen there. I've got the KZN130 turbodiesel, with the A343F transmisssion which is 4.1 from factory. 1st 2nd 3rd O/D Reverse 2.804:1 1.530:1...

As per title, looking to buy gears or whole 3rd members for a 1994 JDM KZN130 Hilux Surf TD, with a factory G295 rear diff (but weirdly missing the LSD). IFS front 7.5" and 8" rear An Aussie or Detroit type locker in the rear would be a bonus! Florida is preferred, but other gulf coast...

thread revival! Just wondering if you ever fitted the 906 rears with the Monomax, and what the rear height was. I've got Moog and Monomax all round, but the rears have sagged quite badly as well. I'm trying to decide on whether to go with the 99 tall springs, or the 906 for the rears, given...

did this swap using the powerstop Tundra kit from amazon last weekend. I'm using 4th gen 16" wheels with spacers to increase offset, and had no fitment issues (calipers looked WAY back in wheel!). Only things not mentioned anywhere I wish I had known, was to: - order a couple of spare pre cut...

yes, thank you so much :thumb3: Searching Poly Armour PAE on amazon brings up all their range with M10 x 10mm bubble flare fittings, from 8" upwards: 308, 312, etc. The PAJ line also seem to be 10mm fitting but inverted flare, which I don't think will fit without reworking...

Are these the linear rate Moog springs? as opposed to the rising rate ones they do? numbers look familiar If so I've got them paired with the KYN Monomax heavy duty shocks, and yes they are very firm on harsh surfaces at low speed, like rutted concrete, but the truck now also out-handles most...

thanks - just found the IAC gasket on Amazon so grabbing that and will strip throttle as soon as it arrives, and replace pipes as they are meant to be as well.

If you ever sell this, please PM me. Seriously... :hail:

Ive been handed another rough old RZN185 (JDM 3rd gen 4 runner with the 2.7 4cyl). It was 'overheating and coolant loss'. Turned out to be throttle body gasket for the coolant bypass was blown, dropping coolant into the inlet manifold, so eliminated mine too for an easy fix (I live in the...

following up I forgot to post up the new alloys and tyres once fitted. I still haven't seen them on any other 4runner 4th gen, so either they are rare as rocking horse spit, or they're off a 5th gen or other Toyota. Supension setup in sig - Hankook Dynapro ATM. Tyres are really impressive -...

i'm in the Caribbean

are these OEM 4runner? are these 16" OEM 4runner? I've been through a ton of picture threads now and haven't seen them anywhere. I've been offered a set for my 3rd gen in great condition, and seller says they came off a 2005 4th gen 4runner. from what I can gather, these will sit about 1/2 -...