Recent content by Brentif

Seats are tentatively held for a member while they figure out pickup. If it doesn't work out, Ill PM you.

Update: Seats have been sold and picked up. Hey All, Finally upgraded to some PRP seats, so I have the stocks out of my 97 for sale. Seats are in decent shape, I recovered both of the seat bottoms, and swapped the cushions so the bolsters are in better shape on the outside edges. Seats come...

Do you have a powered amp, aftermarket HIDs or anything aftermarket that has an external fuse? I had the exact same thing happen to me and it was blowing 15amp dome fuses like crazy. I noticed that the fuse for my powered sub was also blown. Changed that and added a new 15 amp fuse for the dome...

Looks like you are getting some water into the combustion chambers, but probably not a full blown head gasket. You could always try one of those cooling system pellet fixes. My buddies 97 was doing this about two years ago, he popped those in and hasnt had any trouble since.

CA law mandates that there must be a minimum light transmission level of 70%. That does not mean you can use a 30% tint and be fine, since the percentage of tint is the amount of light the film will allow through. Typically auto glass already blocks 8-12% of light, so almost any film on the...

They come rolled up, and the right and left sides are interchangeable, so you may only see part numbers for each side.

I have some of the black rubber moldings at home, i can pull the part number. Just to warn you, its about $250 to replace all of the pieces on the four wheel wells (for a 97 limited at least)

I sprayed Monstaliner on the whole outside of mine, couldnt be happier. Although, I do need to redo it, I had a custom color mixed and it didnt turn out as I hoped. I have all the supplies for another couple coats, just have to get off my ass and get it done.

I have about 30K miles on my General AT2s (285/75/16) and could not be happier. Nice ride, wearing well, quiet, and priced well. Ill be buying another set when these wear out.

You should call the parts department at Manhattan Beach Toyota (in Manhattan Beach CA). They ordered me those on accident, when I needed something different. They may still have them in stock.

hmmmm, size I dont know. What I do know is that they come in a 10 pack from the dealer, and are less than $15 for all of them

Looks like my Yakima ones, i would unscrew one, see if there are any markings on the underside of them.

I just bought those same rotors and pads for the 4runner 231 brakes. Terrible experience, after bedding as instructed the stopping distance was not only worse, but it warped both rotors within two days. I thought maybe i got faulty rotors, put on a new set, and those warped within four more...

I sprayed the whole outside of mine with Monstaliner, never did a write up though. I went the spray route, which was easy to do. The most difficult part is the prep and masking. I went two tone, as to match the existing paint. I used Monstaliner's grey, which turned out fantastic. I opted...

have you tried putting the small screwdriver in the slot and lifting?