Recent content by brisamh

Has anybody dealt with this before? Looks like the very bottom of my TC has a leak where the two sides meet and the red FIPG sticks out. It's torn off in a few places and i believe that's where I'm leaking from. I cleaned everything down good to make sure it isn't the output... What's the best...

impressive Wow this is super clean ... I need to get my rats nest to look more like yours. Any tips or tricks to get all your accessories / fuses connected as cleanly as yours ?

Unfortunately my post was for Burtman, since he's the one I got them from and mine have now started discoloring from moisture

Sorry to revive an old thread-- is the life time warranty still a thing, because I ordered a pair of clear corners/turn signals from you last year and one of my turn signals is clearly letting moisture in every time it rains.

Done Updating this with our methodology for any future readers -- Flemster, looks like you broke off both the top and bottom nuts? In this case the top one was fine. So we took some inspiration from yours but didn't form a U bracket. There's a flimsy metal plate covering the area needed to...

Installed how?? That space is tiny! Did you cut any of the metal back to expose the area.? I'd love to know exactly what you did so I can call off the welder

Update As far as root cause -- I definitely did install that bracket upside down. I torqued to spec, but yep-- the taller part that should have been there went up top and the 1" shorter side went on the bottom. While I did torque to spec I'm sure this is part of the problem.. coupled with the...

So the PO Has clearly either replaced the rack or bushings before. I noticed when removing that the nut was totally threaded. So I ordered a new one before reattaching. Was using a deep socket and CDI torque wrench, wasn't even halfway to the bracket when it snapped. I think despite the new nut...

Never a dull moment ... Final steps of replacing steering rack and bushings. D-bushing bracket has two bolts, top one bolts in to the frame, bottom is a stud that you thread a nut onto. Well while torquing said nut to spec.... Snap. The bolt breaks loose. Can't find any threads with this...

Question -- is yours an auto or a manual transmission? the 234-9003 is for the 5spd, correct? Are the plugs different at all between the auto/5spd or just the wire length? Mine is an auto to 5spd swap, now that the O2 sensors are bad I'm curious if i need to stick with auto plugs or go with...

Follow up For any one else who sees this like I did, here's a solution that I used. 2000 4Runner: the plastic clip behind my alternator basically melted into itself and was physically impossible to remove. After the ordeal described below, there's was a layer of the clip left behind on the...

If anyone got a 3rd gen with sunroof option, I'll take it off your hands :)

Check this out --- Rhino Rack Installed on 3rd Gen 4runner | Rising Sun 4WD Club of Colorado Finally found someone who did it! I'm not sold if I want to go this route. Love the lopro, but it almost seems a tad wider than the roof itself?

Who has one on a 3rd gen?? I can't for the life of me find any pics. Very interested in going this route, with a fairing and maybe side rails. Anyone else running it and can offer some images to convince me to pull the trigger?

Led? Has anyone used an LED bulb for these? The rest of my dash is LED would love to also use an LED for the CEL if possible...