Recent content by burnurass

Sorry I did actually just give these to my brother. BUT, I can sell my current ones I have that are Yellow i'd be interested to sell for the right price.

It was actually my pictures. The light is so much more focused and Intensity was great. Worth the upgrade for the people that care about lighting.

I did sequential. There's some other videos on youtube that show it.

Just purchased this set from Lightwerkz in NJ and had them install it. Everything went very smoothly and we also used the INJ fuse for the Harness. Can be purchased here and if you're in NJ Installation is available Toyota 4Runner (14-20): XB LED Headlights (Gen 2) – Lightwerkz Global Inc...

Bump to the top! Still available.

Install was relatively simple. Turn your wheels and unscrew part of the fender liner and you can access the two screws that hold the light in. As for aiming I just tightened the bracket screws tight and pushed it up or down after the housing is installed.

Up for sale is a pair of slightly used Diode Dynamics SS3 SAE PRO Fog lights in white with the Plugs/Brackets for Toyota. Asking $225 picked up or + Shipping costs Make sure you select the PRO versions which retail for $302 Stage Series 3" SAE/DOT Type B Fog Light Kit (Toyota) Condition is...

**SOLD** Up for sale is a set of Rigid Industries SAE D-series fog lights with the 4runner brackets and pre-wiring so it is a plug and play affair. I purchased these in 2017 but one had an issue with the LEDs. Rigid stood by their product and replaced both lights and brackets. They are only...

-Stock 265/70R17 -Load Rating C -45 psi -60,000 miles total -Stock. -They were great when new. Very quiet, great handling. I used a higher tire pressure because of the higher load rating. The only time they were not good was when it was wet on the ground. As they wore more, they also got loud...

Definitely DIY and take your time. You can break it up into sections. Do a couple doors a night then do the amp and wiring. The most annoying part was getting the wiring through the firewall. Everything else was pretty easy. Definitely pick up some trim panel tools to make the job easier...

Probably driven over 10 hours with most trips being 1.5 hours, so it should’ve showed up by now.

I do get some info. On the same screen as the TPMS one, If my doors are open it shows that. I do get gauge info as well. RPM, Speed, coolant temp, etc. Just TPMS is not working for me. I confirmed the SIL wire is connected.

In the sun, excuse the finger prints. :rofl:

Just spoke to him. He's almost done with a retrofit option for the older amps. Thanks!

Can I add on the sub amp? Then unplug the signal from the original amp to the new dedicated sub amp? And how much is it?