Recent content by CaptainGiggity

Have you since figured out a solution to this problem? I'm having similar troubles

Yeah! that would be it sorry, about the huge delay in getting back to you but if you still have it I'd be more than happy to buy that off you

Do you still have the chrome fender flare on the front driver side?

That is what I was hoping for haha, are some of them bent up?

How much for the chrome wheel trim shipped to 85120? :happy:

I'll have to take a look once I move but I don't have the luxury of time unfortunately so this may have to just leak in the mean time. But I had a bought brand new wheel bearings from the toyota dealership so I'm assuming they should still be good with less than 10,000 miles on it haha. But I...

So my rear axle is still continuing to leak on my passenger's side after I went through the whole repair process the BigFish has written up on here. The driver's side is bone dry so I know it wasn't a fault on my part for reinstalling everything incorrectly, and i'm dreading the thought of...

I previously was running bilsteins on my 98' that came off of a brand new 2013 land crusier with 14 miles on it and they fit just fine for me. They really stiffened up the rear end, but was overall really happy with them considering I picked them up for free:dance: But I recently switched to...

And yes I'm talking the about the 3 that hold the strut in place i haven't touched the one in the center. They aren't stripped they are just completely frozen in place with rust and since I have no way of stopping the bolt from spinning I don't have a way to break it loose unless that...

The problem with that is the bolt doesn't go completely through it stops halfway between those red spacers so you can't put a socket or a wrench on it. I could probably get ahold of the first one, but then the trouble turns into how the hell am i going to get the back two?

So I've moved on to the front half of my truck to put on my new boss lift kit system from toytech and I've noticed a problem that I'm hoping won't anything serious. I'm aware that it a very crappy picture and I apologize in advance, BUT! The previous owner/owners before me thought that putting...

It's amazing what lube can do, I literally pushed it on to that midway point and smacked it once with a rubber mallot and it it flew into place! Thanks guys for helping me with this but I also gotta ask, the adapters that were on these shocks aren't even tightened down how much did you guys...

The last time I installed shocks on here I started at the top then bottom but starting either way doesn't help me it just keeps getting hung ip it that one spot... But i'll have to do some digging and see what I can find. Thanks for the input though!

So I just got the Boss lift kit system that toytec had on their website and i've looking forward to this day when i finally got everything to start putting it on.:banana: I started with the back first and getting the old springs and shocks were a piece of cake but I'm trying to put on the new...

haha how'd you know that man you're creeping me out! And Apache Junction is pretty much grey hair central during the winter...