Recent content by cb49er

I have an 03 4runner cigarette lighter that is a bit loose and sensitive to any movement causing power to turn on and off. It's extremely annoying, especially when I use my bluetooth adapter. Do you guys think it needs to be replaced or can it be repositioned correctly? Thx

made a bike rack

I removed all the ceiling handle grips and screwed on some hinges that have a ring in which I use bungee chords and Velcro to lay and hold the poles in place. I'll try to post a picture later. It's for my 4th gen but maybe it'll work or give you some ideas.

Local family shop, I've done earl scheib years ago and hated it.

got it painted, clear coat was bad and had lots of really deep scratches. Paid 1500 for 2 coats of paint and clear coat, I happy with it.

I removed my lower cladding that was faded and peeling so that I can attempt to paint it with aerosol cans from automotive touch up paint. I've ordered the orange/blue clips and the adhesion strips that go on the cladding but I can't figure out what # these little rivets are, anybody have any...

a few posts I'd seen mentioned how much it was a pain and that there were some screws involved. I have an 03 in which I plasti dipped the trim but I want to take them and the lower cladding off and try painting it. Did you guys just do the same and pry the cladding off as well?

So I just purchased this car but I want to replace the bumper since it's cracked and oxidized. It had the appearance package since all the trim is color matched. My question is, were there 1 piece front covers for the SR5? I've taken it to a couple of body shops and when I give them the car info...

Just taped around the emblems and then peeled the overspray off with the tape. Just youtube plasti dip emblems. Quoted wrong post Sent from my iPhone using Tapatalk

replaced front hood supports, and plasti dipped wheels/badges/front grill

Have 246000 on my 03 sr5. Got it almost for free since family member just got a 17 sr5

I know it's a long shot but looking for an 03 sr5 gold front bumper

Can you post the eBay sellers name, been thinking about ordering a prepainted bumper. Thx

my VSC and TRAC lights came on after battery issues. I took it to get scanned for from and got a C1336 zero pt calibration code. Did the paperclip method and even though the lights didn't flash the same as previous examples, in the end they turned off. Glad I took it to confirm what I expected...

vsc and trac off lights popped up after I had troubles with my battery, so I took it to o'reilly's and a scan showed zero pt calibration which I figured was the problem from searching on this forum. Did the paper clip method and now the lights are gone. Such great info on this board that saves...