Recent content by chadw73

so i used the handheld on it today and its throwing codes POO51 and PO455. I am assuming thats 02 sensor bank 2 sensor 1 and that may fix the other code also. Any suggestions or comments?

VSC Trac and VSC Off lights just came on with the engine light. Some of the forum pages have shown that it was a gas cap so since they are not to pricey i bought one. My question is, do i replace the cap and then use a handheld to erase the codes or do i need to do a zero point calibration. Any...

If i go with the 3 inch lift would i need to get UCA's also as im getting some mixed reviews on if they are needed or not.

Thanks for the info, Really all im trying to to figure out is if i do the 3 inch suspension lift do i need to do UCA's also. Money is not the issue i just was trying to say i dont need a lift with super high end shocks and things like that because it wont be off-road much. Im just trying to get...

The money part isnt an issue i just only want what i need, and not something thats way more than i need. Im wanting to do a 3 inch lift and was considering the toytec/bilstein 3 in. lift but at like $1200 is it more than i need. Also with going 3 inches is it necessary to go with upper control...

Also is it possible i might need a 1" body lift to prevent some rubbing with less cutting?

Just picked up a 2003 limited and was wondering what lift i should go with? im wanting to do a 3 inch lift with 33's with no plans to go offroading. This is my daily driver and just trying to make it look good. As far as a mall crawler set up what would be my best route to go as far as a lift...