Recent content by Chingpo05

wish I were able to help yall, with my work schedule I barely have time for my own stuff :sadwave:

its correct. its just the top of the spring did not have a nice taper, give it some time and the ride quality should change

most shops wont do it unless its an insurance job due to the fact that it takes so much time and not worth pissing you off by quoting you so much. it will never drive the same unless you chop and re-weld a whole new piece in there. even after all the work it still wont be even close to 90%...

my complaint on most aftermarket racks, esp the cheaper ones, are too high. It drags butt on the highway and does not clear most garages if you have a lift. I took my yakima off and put it on my brothers CRV and will be building my own low pro one once i get some time to fab it up

replace the thermostat, burp it, then let drive it. if it overheats on highways then the hg is blown, if it overheats all over then its another cooling issue or the hg is far beyond blown

change you plugs to the oem double prong to see if you will have the same issue. add a little bit of anti-seize to your threads also to save your head for the future

mechanics usually charge approx. 600. coolant, pump, seals, belt, drive belts, tensioner pulley, and tensioner. you could save yourself some coin and buy a gates or Aisin kit. Gates used to distribute for Honda and Aisin does for Toyota either one is fine. In my 15 yrs of messing with...

this type of gasket that is supposed to be used is the donut gasket. its a huge gasket that Honda's typically use and it seals a whole lot better.

autel makes some pretty friendly scanners for a great price

lucky you that there is a tool for it now that is easy found. I had to fashion one out of bar stock I had with the 2 12mm bolt holes and a huge hole for the crank bolt socket.

I should fit all the way up to 01, 02. I have a 98 on my 00 due to a planetary gear failure, common on the 00 +

ahhhh, that blows, they kept it on many other of their vehicles though.

you guys go through a lot of trouble doing this cutting and all. I just unplugged my DRL box next to my battery, 2 pin wire, and it works just fine 2000 runner

yea I have a 1 3/4'' and 1'' die for the bender.

I have a tube bender here in Austin if you want to make a full tube rack