Recent content by Chipmunkyota

A chipmunk chewed off wiring for the turbine input sensor and I can’t tell where the wiring is supposed to go. This is near the front of the transmission on the drivers side. Can some folks please share a pic of where their wiring heads to?

They mean the pad won’t be sitting in the rotor and allows for airflow. Will add wear to the transmission though.

I just carry a sharp ax. Couple minutes for a good size fir, but never needed to clear a trail.

You could try low profile chains sized down one size for tight fit if fronts must be run. Don’t drive then on pavement, might pop off!

Yes, any car these days. My fj up150% in 3 years.

Still have?

Input sensor to be clear.

Also have the front sensor chewed off. Can anybody send a photo of where the wiring goes to from the sensor? Maybe the bundle above the trans? Only 8 inch section chewed off. New member can’t start a thread!! Thanks

Post wanted sign on the outskirts of town in lower income neighborhoods where people might rent land or garage for cheap, but might want to haul tools then.

Crate for sleep.

Z chains are low profile and easy on. Still might hit body mount point with no lift.

Anybody installed this yet? Would you diy again?

I used a meter that goes in the cigarette plug and has 3 usb outs. Many options online.