Recent content by ChucktownRunner

Replaced my hatch weatherstrip and it is scratching my glass. Anyone know why? Sent from my iPhone using Tapatalk

You can use the reverse polarized film over the display. Search the forums for it

Yes sir. PM Sent

You can also get an AM/FM Transmitter also Sent from my iPhone using Tapatalk

It depends on what your end goal is for your t4r's audio. If you're just looking to get your aux back I would look for a replacement stock. You could also try to figure out why it's auto ejecting (google&youtube can pretty much fix anything). I don't know if your car has a factory amp. If it...

Sorry for some reason I never got a notification about your post. Depends on what's easy to you. I don't know if the wire harnesses would match but you can always splice the wires together. If you had to do that and really wanted to make it easy you could use the splice twist caps. Personally I...

Bump Sent from my iPhone using Tapatalk

I thought about super glue but wasn't sure if it would hold vibrating from the components. I have 3 layers of dynomat on and in the door but not on the actual panel. Sent from my iPhone using Tapatalk

Anyone had this issue before. The gap between the switch housing and the outer panel is getting larger over time and causing rattling when music is turned up. Any tips on sealing it up? Sent from my iPhone using Tapatalk

Saw where someone did this and caused the clip to blow while they were driving. All I remember reading was no one got hurt but he did a lot of damage to the truck. Put the stiffer moogs back on (less sag) and max the bils the right way until you get new UCAs to go higher. Sent from my iPhone...

Check what ukbloke said. I've also seen a post on here with similar results after their install. They ended up realizing that their springs were upside down. Something is definitely not right

It blew a few years back and replaced it with a bazooka 8 in drop in from an audio store around here. Still have it if you're interested. It'll work with factory JBL package Sent from my iPhone using Tapatalk

PM'd

When you took the dash apart did you mess with the bolts above the cluster? They tighten the two ports of the cluster wire harness into the cluster. You can only tighten them so much before they start to back the ports out. I'll try to find a picture of the bolts It's the top two in red. I...

194s