Recent content by Combatman

The drift is just at highway speeds, and seems to depend on the crown of the road now that they switched the tires around. I'm not to concerned with the drift as much as I am about pre mature tire wear. After about 1200 miles the little string rubber stubs that come on tires brand new are gone...

Ah alright. Now if I leave it as is am I likely to see significantly more wear on the outside of my front tires? If so I want to nip it in the but immediately as these are brand new tires.

So if I just adjusted camber myself, would I end up with toe and caster out of spec?

They wouldn't give me my money back, but I finally got them to offer me a camber adjustment for free (at first they wanted me to pay an extra $50 for it), but they would only do it if I told them where I wanted the camber at. I had no idea, and I had to take trip out 6 hours away last night, so...

I'm brining it back in today to get it checked, is there anything I should say while I'm there? Should I be mentioning that they mostly just adjusted toe? Edit: so they gave it back to me, said they swapped the front tires and took it for a ride and now it doesn't pull. I looked at the tires...

Pulls to the right, sorry. I took it in after the alignment because it looked like the toe was off a little, but they said it was normal and my toe was off before and they said the fixed it. I have no idea how to tea the alignment sheets though, so I just took their word for it Edit: here's...

So I put tacoma suspension on the front of my 4Runner then put some 255/75r17 tires and got an alignment with the tires, and now on my last two 6 hour highway drives (both ways) it pulls to the left when I levy off the steering wheel, and I'm constantly giving the wheel left pressure to go...

Well I just put 255/75r17 Hankook Dynapro ATMs on my 4Runner 3 days ago, i have only done the front tacoma suspension swap (leveled the front with the back with no rear lift so probably 1-1.5" front lift) and I have noticed no rubbing yet. I have a set of wheel spacers I haven't put on yet...

How far from the eastern boarder of CO is Winterpark?

I know this was forever ago, but do you still have these?

In line in case it doesn't sell

Also I'm quite curious how much lift you got with the FJ coils on a 3rd gen?

Next in line after Fletch

Has anyone ever considered swapping the 5th gen 4Runner suspension into a 4th gen 4Runner? I have to think those 5th gens are a good bit heavier, so it should provide some lift, I just wonder if mounting is the same, and where I could find some info on the shocks/ springs

Just fixed a similar issue on my 4Runner that I just got. The PO had a Cat replaced before they sold it and there is a bracket that goes from the cat to the block with one bolt on the cat and 2 bolts on the block. Both of the bolts on the block were loose and the bracket and associated washers...