Recent content by CrawlerJamie

Interesting development.

At it again with another 4runner buddy :) https://youtu.be/pjLy0HN0ICw

Had my front skidplate bent And fitted it. The whole underneath. Pretty flat and smooth! Cost me about $225 for all these skids so far. Very happy with them too.

The whole underneath. Pretty flat and smooth!

Had my front skidplate bent up

Got latches figured out....now for paint :D

Thank you, I had a few friends stop by tonight so I didn’t get much done. Did get one latch together, and cut a couple plates for the other side. Basically the part of the latch that goes onto the door frame, has to accomplish a couple things. It has to grab the male end of the door latch...

Yeah she’s road worthy. I drive it wheeling now that is has good tires. 30-45 mins each way highway. Cruises along damn good! Not sure I’d drive it to Moab, but I would trust it to make it. It’s not that bad but there was a bunch wrong with it. Worn out bushings, lights on the dash...

Knocked out the other door. Started figuring out the latches.

Fitted the last couple tubes on one side. began work on the passenger side. Should get the latches tomorrow. Ill finish this door hopefully, and work out the latch assemblies. Need to trim the hinge plates too.

Fitted the last couple tubes on one side. And began work on the passenger side.

I’ll figure something out for mirrors, won’t have speaker mounts though. Going to pull the wiring harness out of my extra door and cut it down so I can still control the rear door locks and windows. Should be able to pickup some tube today and get th drivers side squared away. still waiting...

Used the last bit of my tube for this bar. Turned out nicely. Once I get more tube I’ll finish this door and move to the passenger side. Got my tcase and transmission skids bent and on. Coming up with the front skid should be interesting. Should give me a little more coverage than...

Thanks man. Used the last bit of my tube for this bar. Turned out nicely. Once I get more tube I’ll finish this door and move to the passenger side. Got my tcase and transmission skids bent and on. Coming up with the front skid should be interesting. Should give me a little more...