Recent content by crutt

Elocker I've got a 3rd gen elocker complete rear axle drum to drum and matching front diff. 4.3. $650 north Dallas.

Sold! SOLD. Went off to its new owner today. Already sad.

Thanks guys! Like I always say, if it doesn't sell I wont be heartbroken.

172k miles, 4x4 Automatic Fresh rebuilt supercharger Water methanol kit, Leather interior, Bilstein 5100/Eibach springs in the front with differential drop. Land cruiser coils and rough country shocks in the back. Budbuilt front and belly skids. Tundra 199mm brakes up front with new centric...

Ended up not using it, never opened the package. Retails for 190. looking for 170 shipped Obo.

Hey MTD, I think your pin for Mag style Cam 1 sensor positive input (24 pin, #5) is actually 24 Pin, #9. #5 is for the Cam 2 Sensor Positive Input, not 1. (**** THATS CONFUSING)

I'll see if I can get you a copy tonight, I'm pretty sure my 96 diagram should be the same.

So am I wrong in not finding an aem harness for the type C ecu? (97 v6 automatic)

I gotta pull out 4 ounces too then. Argh. Maybe this is why my nose seal is leaking after the rebuild?

The stock rubber tube i was using developed a crack in the elbow, noticed it when I went to take it out to reinforce today. Anyone have any tips for completely replacing it? Or am I gonna have to play toyota plumber at homedepot?

Pulled the efi fuse for a few minutes. Starts up, then dies. I was able to keep it kinda running by spraying some tb cleaner on the drivers side of the supercharger. I cant tell where it might have a vacuum leak. Found the issue: loose bolt on the bottom inner sc housing. I'm a moron. Anything...

MAF is on the correct way. I had my wife start up the runner and i ran it by modulating the throttle. I could see the BPV modulating with fluctuations in boost, but it still died when i let go of the throttle. Now I'm stuck, anyone got any ideas? https://www.youtube.com/watch?v=prIiatx7_74...

So I just finished installing a 1st gen sc on my 97 today, car starts up fine, high idles at 1500 for like 2 seconds, then stumbles and dies. I have the FPR hooked into the boost barb on the back of the sc, the small barb near the tb hooked to the tb barb, and I tee'd in the line going to the...

Lumbar switch for drivers seat? and how about the switch covers for the passenger seat controls. Also need a window lock button cover thingie if youve got it.