Recent content by Dannywaskie

***Truck is sold as is.*** Make an offer. Throws occasional general misfire CEL on cold start, possible headgasket issue. Drive it and wheel it as is, or do the headgasket and drive it for another 200k miles. V6, always professionally maintained. Old Man Emu suspension, Total Chaos UCA’s, sway...

I'm not super excited about the gap either, I'll address it by making some new mounts the next time I need to take the bumper off. The roof box is an old Thule mountaineer. Mobtown Offroad Weld on Sliders, no kick out. They make awesome, heavy duty stuff you can actually wheel on. They're also...

06 4runner v6 5100 w/ Toytec Springs rear OME w/ OME Heavy Springs Total Chaos UCA Body Mount Chop Toytec 1" BL 285/75r17 Cooper ST Maxx lots of trimming, pinch welds hammer'd etc. etc.

Bilstein 5100 front shocks w/ Toytec/Eibach coils Used for about 2 years, almost entirely highway miles. These have stock top mounts. Shocks work great, selling because I went to an OME setup to support bumper and winch. $250 shipped

I don't see myself going over 33's. I just clicked through the thread where you purchased your truck, looks exactly like what I'd like my build to end up as. Everything felt and performed well with bumpers, RTT and the works?

I'll check with fedex/ups and see what shipping costs for them if you'd like. I'm assuming it won't be a great number. Send me your zip code and I'll do some math.

06 v6 with toytec springs and 5100's 255/75/r17 Cooper ST Max. These photos are before wheel spacers.

What are you running that you feel you need to go to something different than the 5100's? I'm looking to add sliders, skids and a front bumper and winch and I'm worried I'll be running into similar issues.

Kuat Half Basket $250 This is an awesome piece of roof rack gear that occupies way less space on your roof. It has a 9mm QR fixed bike mount (fits any and all popular thru axle adapters) and an included locking cable. Great spot to put a jerry can, maxtrax, firewood, recovery gear or whatever...

I'd love to hear options for this as well. I currently have 5100's with toytec 10% heavier springs, with a rooftop tent. I'm planning on doing an arb bumper and winch, as well as sliders and skids. Do I need to think about doing OME stuff or can I run the OME heavy springs on my 5100's?

Would you happen to have a part number for these?

Just purchased 5100's and toytec springs front and rear. I'm looking to fit 255/75/17 cooper at3's. Anyone have any suggestions on where to set the front spring seat? I was thinking the .85 position as the springs will give me 2 inches in the front?

Hey Phil, Just curious where you ended up purchasing your 5100's from. I'm looking to source some FJ coils soon and ditch my XReas. Did you end up needing anything else initially to do the install?