Recent content by djmedik91

Are the headlights still available? And how about the yellow fog light hulbs? Are they the bulbs for the fog lights that were installed at the port? Those would be the rectangular ones? Thanks!

Man. Glad to hear that you're ok from that. Looks like that roll could have been bad.

This is true..... I just wasnt sure if there would be clearance issues with the window. I know I could some test fitting, but it is too damn cold to be outside for the time being.........

So not in between the door and the door molding but inside where the glass is? I tried in between the door and the door molding but I think the x-over is too thick with the cover on. It "works" but the molding doesn't snap back into the door like it should and juts out towards the hinge. On the...

If anyone has them, where did you mount yours?

I'm running my 15" BTL with a Crunch GP3000D and the stock electricals do not hold up at all. I think I only have the gain set at 1/2 with the bass on the HU all the way down. If I turn the volume up to 20 on my Alpine HU, and a hard bass note hits, the HU shuts off along with the amp. I've got...

Just a little "fap" for Eskimo's avatar.................

Unfortunately, that amp is one of the amps that does not do its rated power. I had that amp running my Alpine 12's. It probably only does about 1/2 the power that is stated, so each of those subs is only going to see about 200-250 watts. Now don't take what I said above the wrong way. Again...

I think Clemson was quoting that wiring for a dual voice coil. I believe the JL's that James is referring to are single voice coils. There are a lot of factors that come into play when picking a sub setup. Type of sound you want, what music you mostly listen to, how much room you are looking...

ttt.......

$115 shipped.....

Nope. Only running 2 gauge for the time being. I used 2 gauge on my last amplifier, which was a crappy Power Acoustik that did about 40% its rated power. However I will be running 0 gauge when the new alternator comes in, and I will also have to upgrade my big 3 wiring from 2 gauge to 0...

Thanks! I ended up dishing out $200(shipping included) for the alternator, and it's never been installed. I did do some research into going to a larger capacity alternator, but from what I have heard, you can actually lose amps at idle. They will still put out what they are rated for, but at a...

$125 shipped.......................

Thanks for all the input guys. I went ahead and scooped up an Iraggi 220A. I'm pretty sure it’s a GM CS-144 alternator but rewound with higher amps. It's new, never been used and supposedly does 150A at idle and 220A at full tilt (wherever that may be). I've heard mixed reviews about Iraggi but...