Recent content by dozerfrelich

Is a good diff locker rear axle still available? Sent from my iPhone using Tapatalk

I have a rear hatch issue, 99 limited, the key hole works on the outside to roll it up and down, power locks work as they should but nothing else does. Sometimes I can get it to work when I disconnect the clip in the photo and reconnect it. I checked for broken wires from the hatch to body and...

Still available? shipping to 54935?

Good morning, I am in the market for a 3rd gen that has no rust, light surface rust on the frame is fine but the body must be rust free. small dents and scratches is fine also. Prefer to have it have OEM rear locker but not a deal breaker.

4xinnovations in Platteville WI Sent from my iPhone using Tapatalk

Another way is to rent a reverse jaw puller with threaded rod or a slide hammer. Sent from my iPhone using Tapatalk

If I remember correctly I put mine in at a 45degree angle until the near side as past the bearing. Then with the one side pressed firmly against the bearing thread the bolt in and slowly suck the plate flat. After that everything should go as per the instructions. It is very tight in there so...

Payment sent! Tapatalk drops the ball on notifications haha Sent from my iPhone using Tapatalk

Yes after windshield is out in but before the weather seal. The weather seal helps push it into the small areas. Sent from my iPhone using Tapatalk

I cut my bad sections out and welded in fresh steel. It doesn’t have to look pretty it just has to be structurally sturdy for the windshield. When I had the windshield put back in I put silicone all the way around the window before the weather strip so when the strip was put in there was no gap...

What year is it? It sounds like a failing brake booster Edit: just realized that trac would be 01/02. I’m guessing that it goes away once the engine get close to operating temperature? That to me would mean the seals warm up and expand allowing the pressure to build up. That would explain your...

Hello I just wanted to throw out there that retrofitsource is have a Black Friday sale were you can get everything including halos for 285 shipped roughly. It says it will be ending tomorrow night. I will be making a couple sets for me and a few others so if you would like I’d be willing to make...

I put a pry bar in between the studs and use a breaker bar. You can do the same method off the truck but it’ll be fun Sent from my iPhone using Tapatalk

With winter knocking on the door I would remove the running boards and the plastic skid plates right away and get some rust converter. Just scrape off the big flakes and spray it on for now to slow down the rust. Yes you will have to wire wheel it off later but for now it would help. Sent...

Did it just not come with remotes? I thought mine didn’t have it until I tried putting it into program mode and it worked. Sent from my iPhone using Tapatalk