Recent content by Drgriff

Thanks for the advice. I decided to order some of those bolts and will replace them all before I reinstall the 3rd member. I assume the torque values are the same-18 foot/lbs ? That's what I saw on Timmy the toolman's video

I’m having to replace the rear wheel bearings and 3rd member. I got everything taken apart and had a small issue. When I was removing the nuts on the 3rd member, 4 of the studs came out instead of just the nut. Before I reinstall the replacement, should I try and to get the nuts off of these...

I recently bought a lifted 3rd gen with worn out CV axles and I ended up putting on a set of these. Seem to have better articulation than the ones I removed. I will be honest though, I'm new to 4runners so my opinion doesn't count for much

This is an old thread but I have a question for the group- what part of the rear end causes the whine? Is it the third member bearings, the third member gears or the ends of the axle shafts? If you have a worn out rear end like the original poster, will replacing just the third member fix the...

I've been hooked on Mr. Ballens podcasts-Redacted, WarTime Stories and Medical Mysteries. Very well done. Oh, and Run Fool

Welcome

Love the wheelin' pics

Looks good!

I ran a hot wire from the battery to under the center console and installed a fuse block to add charging ports in the front and at the rear door. Found a really nice panel on etsy to install in the back.