Recent content by DriftingOverland

And with just adding “oil, gas, and tires “ (plus a few toys) I bet[emoji106] Sent from my iPhone using Tapatalk

Ya I was surprised to see it (spare) pop up! Glad too as I was in the past “one of those” who assumed the spare on a car was “ok” until you attempted to mount it and found out it was almost flat! Sent from my iPhone using Tapatalk

I had the TPMS installed in the 5th when I switch everything out to KO2s. I wanted 5 tire rotations with ease and it works fine. The 5th wheel is displayed on the dash display. Sent from my iPhone using Tapatalk

Dumb? Nope… I call it motivated. And success FTW! Sent from my iPhone using Tapatalk

Might start here if you don’t want to make too many modifications and stay DOT/SAE compliant: SS3 Pro Fogs are nice… Automotive LED Replacement Bulbs & Lighting Upgrades Sent from my iPhone using Tapatalk

Finished my drawer system. Just need that stove to get here…now on to building the fridge slider. Sent from my iPhone using Tapatalk

Done Sent from my iPhone using Tapatalk

I’ve got OME 889’s (medium) with my drawers… about .75-1” difference (higher) in the rear. Sent from my iPhone using Tapatalk

Work in progress… 80/20, bit of wood, and spray on bed liner…my version of GooseGear. Still need to finish out stove slide and start working on fridge slide. Sent from my iPhone using Tapatalk

Nice! Being a little OCD, I love the consistency in everything… yellow.[emoji109] Sent from my iPhone using Tapatalk

Nice choice! Got the tread plate version on mine with kick out…yes easy install and happy. Rattle can bed liner holding up as well! Sent from my iPhone using Tapatalk

[emoji23][emoji23][emoji23] If it were that simple… wait… I bet it changed the gear ratios too! Sent from my iPhone using Tapatalk

I would have done what Rage did but lightbar wire runs on driver’s side and and right/left scene lights run in passenger channel. So… the reason to run them from the rear via the grommets/boot. A little more complex but it’s what I wanted to do… After “3” the wires run down the driver’s...

These were run off the back and into the rubber boot under the spoiler (making the smallest incision for the wires) then siliconed up. Wires run down c-pillar on drivers side. Then they were threaded through wheel well, kick boards and then firewall to my Switch-Pro. And check out this for...

Dang! Well done! Now with your luck on a roll…go buy a lottery ticket[emoji23] Sent from my iPhone using Tapatalk