Recent content by dsanford

New Duralast AGM group 24F, alternator, ignition coils x6, serpentine belt, idlers x3 and tensioner. I see now why people try to just replace the idler on the tensioner bracket. Changing that tensioner assembly was a CHORE! While putting the battery back in to finish things up, I noticed the...

X-REAS Delete and put Bilstein 4600 shocks in the place of the originals keeping the original springs.

Got the LED Flasher relay from Diode Dynamics, adapter harness from Toyota and new LED bulbs in. Previously I had LEDs in the rear with a built in resistor from LasFit. I really liked them, they were super bright but only lasted 2 1/2 years and at $50 a pair, I couldn’t justify the price tag of...

Leveling kit installed. Before and after pictures below. New tires going on tomorrow and wanted to get this done before that. Leveling kit is Icon Vehicle Dynamics, new tires will be Cooper AT3 4S in 265/70/17. Now I’m debating on removing the side steps because they look like they have a...

SurferUK As small as the filter is, there really isn’t a chance it is going to effect the fill level. It is no where near the volume of say a engine oil filter which may hold 1/2 quart. I assume Drcoffee is using the 1/2” black plastic version which differs from the version Bluesky 07 is...

I agree with Drcoffee, now would be the best time. Also since the filter goes in line, it will be saturated soon after start up so no need to pre fill the filter. It will not effect your fill level. You may not be interested in a drain and fill but you may consider it. Yes it is not...

waypoint Thank you for the information and the picture. After changing the valve cover gaskets and peaking at the tensioner, I saw the variations on the piston of the tensioner and I knew I needed to look at the tensioner behind the inspection plate. What you are saying totally lines up with the...

Currently my mileage is 226,000. I would be interested if anyone has a measurement for how far the tensioner is extended on a new timing set. Based on what I have had to replace or fix from previous neglect, I would assume it is only a matter of time until I do get this DTC. Also after my oil...

Sometimes OEM is best, sometimes aftermarket is best. In this circumstance I believe the aftermarket fluids are better. I can’t blame others for choosing to use OEM fluid, especially with one of the largest components on their vehicle which can be very costly to repair, replace or worse...

Pictures???

I’m hoping to get some input to either verify or debunk what I assume is a worn timing chain. After I purchased my 4Runner early last year I noticed signs of sludge and after doing my valve cover gaskets I confirmed that the previous owner/s did not have a consistent oil change regimen. This...

ATF fluid exchange to Valvoline synthetic. Installed Magnefine filter. Also serviced the driveline.

Successfully completed this fluid exchange this past weekend. I used about 12 quarts to complete the exchange. I did the process by using the trans cooler lines that come up to the radiator and filling through the fill port on the trans. The process was very easy once everything was set up to...

aemravan This is genius. I was looking at different attic ideas over the weekend some were ridiculous! Like $200-$300 with options. What you have posted will definitely fit the bill for me. Thanks for the post.

Cleaned and lubricated all weather seals in preparation for the winter. Had to do the girlfriends car while I was at it. Took out the rear WeatherTech to set it in the sun to flatten it out.