Recent content by FattyHunter

I have this issue since 2020, never replaced anything, it corrects itself. If you are bothered by it, there is a bypass kit. It happens when there's a lot of snow and only if i parked outside. Secondary Air Bypass Kit: Gen 2 (Plug & Play) | Hewitt Technologies There's Youtube videos about the...

What is different about the 2023 Pro lights? The FBC site stated that the 2021 lights are low-beam LED only, while the newer ones are Bi-LED, and there's a shutter to activate the LED high beam. I followed the YouTube video above and got mine working. Mine is a 2022 set; it has three wires, one...

Emailed.

Not sure if this helps any, I have nothing to compare to, but the lights are great to me.

I went through this recently, I was running Morimoto HID in a set of 2015 OEM housing and they were great, aim them properly after you install them, that's the best option as they're bright. Then the headlights got dull and old so I wanted new housing. I was patient and kept looking on the...

Are you running 285/70R17? What pressure are you running them at? Thanks

That's good to hear, I'm excited, I have a set getting installed right now as I type this at Discount Tire. 265/70r17 (left) going on my brother's Tacoma vs 285/75r17 (right) going on my 4Runner.

I got the blank cut, went to Walmart, the quality of the cut is not great but it works. I'll probably grind the factory key down when I'm bored.

I ordered mine when the email goes out, got it yesterday. I got black because I didn't have a special color 4Runner. Cutting the transponder is not that bad, took me about 10 minutes to get it out with a box cutter. It does come with a blank and TRD cap for the spot below the flip button, I used...

I bought lugs from SCS when I bought their wheels as well, 70k miles with them, and no issues. M12x1.5 ET

Like the post above yours, I'd have the shop torque the bolt as well.

Are you running aftermarket control arms? I had the older SPC arms with the older bushing where the cross bolt goes through, makes the same noise after a while because the inside of the bushing was dried.

Do you have pictures of your setup? Kings, Fox and possibly Radflo have spacers to relocate the Sway Bar forward so it doesn't come in contact with the coils. I ended up removing the oem support bracket and bought an ARB kit that has a support bracket that will clear the sway bar with spacers...

Not white, hope its ok. SCS F5 17x9 on 295

I think that works with Prinsu rack only right now, did a quick search and it's called a side load access panel. Pretty cool.