Recent content by Franken4Runner

Thanks for the replies, they are very helpful. I believe they must use a drive on lift so the vehicle will be angled as it does when on the ground.

I have a 4Runner with Bilstein 5100 and OME springs, its level and does not have the rake that is present with factory parts. I had it in a shop to have an alignment (custom alignment spec due to OME upper CAs) and they brought up when filling the transmission fluid of vehicles that are lifted...

I have a 2011 and clearcoat on my sharkfin is in bad shape, surprising since the rest of the vehicle good. I noticed that Toyota sells covers that are pre-painted but shows they only work for 2015+. Does anyone know if these will work on a older 5th gen? The cover is part# 86077-60010 + the...

I bought the Toyota kit and am wondering where are you supposed to apply the sealant? On the bolts (threads) or around the white plastic inserts?

I was quoted $950.00 for labor for the same work + an alignment. Depending on your mileage I might have the LCAs replaced as well since they would have to be loosened or removed anyway. I ended up doing the work myself, only saved about half since I "invested" in a battery impact and a new...

The rear differential fluid is very easy to change, its basically idiot proof. Just get two 12157-10010 crush washers and 3 bags of your choice of synthetic 75W90, I used Valvoline Advanced. Took less than a half hour with most of that waiting for the old fluid to stop dripping out. Compared...

New Front Suspension Parts and Lift Kit This was longer than just today but over the last week I installed a lift kit, new front upper and lower control arms, front and rear swaybar endlinks and outer tie-rod ends. Did all this on the driveway with hand tools + a battery powered impact. This...

I have a 2011 SR5. A couple years ago I bought, but never installed, Bilstein 5100 struts/shocks with OME springs for my 4th Gen. I recall estimating it would raise the 4th gen about 3.5" in the front and 2.5" in the rear but I know the 5th gens are heavier and sit higher from the factory...

Intro I just bought my second 4Runner, a 2011. I also have a 2005 which I am going to be selling once I finish modding the 2011. I will post a thread on it when I am able to post!