Recent content by franky73

Fueling up yesterday the strap holding the rear of the fuel tank failed due to rust. Thankfully I was a couple blocks from home and managed to strap it up. Trying to find a replacement today and looking like it will be quite the wait. I am thinking I will just make one and I am hoping...

Hoping someone has a definitive answer. Going to order in the next day or two to catch up with the rest of the parts on order. Hoping someone can also confirm the appropriate part number for a tundra dust shield. Believe they should be; Right - 47703-34031 Left - 47704-34031 Thanks

The big one for me is not having the CVs spinning all the time. Going through a lot of boots with the lift. I also really like the idea of being able to use 2 low for steep hills with a trailer as well as being able to disconnect an axle if you break a CV to list a few. I had them on my 2nd gen...

Appreciate it JZiggy. If I can't find anyone with the for sure answer I might just give it a try. I cant see why the tundra shield wont fit but you never know.

Hey Everyone, I am planning a manual hub swap shortly, just finding the final pieces. Going over the truck the other day I noticed the dust shield is in terrible shape and I will be replacing it at the same time. Hoping someone can confirm that a tundra dust shield will fit without...

Awesome to know the 2002 shafts will work... I have some older bearings kicking around from my previous truck that are the pre 2000. Is there is true difference in the two bearings? Bearings I have on hand are 9036340020 and dust seals 90313-48001. If I am reading this correct I can use the...

I recently had a similar issue. Ended up being the rear u-joint.

I managed to pick up a 1996 elocker to swap into my 2002. Unfortunately the unit came with no axle shafts. I am hoping to use mine from the 2002 as I was planning to do my rear seals and bearing at the same time. I have searched and searched but seeing as there are different part numbers of...

Sorry to revive an old thread but I have looked and looked and cant seem to find what I am after. I am working on an e-locker swap into a 2002 4runner. I am trying to confirm if the diff lock indicator is in ALL gauge clusters or if it was omitted in the 2001/2002 models? When I put a bright...

I heard back from Amayama today. The manufacturer has made the substitution themselves. We can't request that they go back on it. It doesn't matter what a Toyota dealer says, the manufacturer has stated that the substitute part number will be supplied in lieu of the original. They state that...

You guys are confirming what I suspected. Parts are coming from amayama.com as camelback and the likes will not ship to me in Canada. I looked on their own parts look up again and they are listed as separate part numbers. I also called my local stealership who also confirms they are different...

Hi T4R, I am working on ordering parts for my front end rebuild. Ordering the lower control arm bushing I ordered two 48061-35050 and two 48061-35040. What was shipped was four of part number 48061-35040. When questioned about it they said "The manufacturer substitutes part numbers at their...

I had the same thing. Turned out to be the o-rings on the fuel injectors.

Exactly what I was looking for. I am thinking I should probably pull the transmission. I watched the video from Timmy on replacing the transmission and it really didn't look as bad as I was thinking.

Got a 2002 with a long term leak from the rear main seal. Increasing quite a bit lately and now I am having to top up between oil changes so it is time... Apart from the rear main is there anything else I should be looking to do? I am thinking possibly the flex plate but not certain its...