Recent content by Freshly-snipes

much appreciated, i must have missed the free section. Hoping someone will want it and give it a new life

I have a 1st gen hard top that I dont need taking up space anymore. The outside has exposed fiberglass from sun damage and the rails are rusted. Definitely would be a project. Inside is pretty nice still. Came off my '89 1st gen. Honestly not sure if this is even worth something to anyone.

I have a 1st gen hard top that I dont need taking up space anymore. The outside has exposed fiberglass from sun damage and the rails are rusted. Definitely would be a project. Inside is pretty nice still. Came off my '89 1st gen. Honestly not sure if this is even worth something to anyone.

I just did the marlin crawler seat and bushing install, but a few weeks later I went to disassemble again and when I tried to remove the shifter, the bushing is now stuck in the turret. I tried everything to get it out. It spins freely and can move up and down about a half inch, but gets stuck...

Same thing happened to me. Got a nice gouge on that inner surface thats hard to access. Did you do anything to fix that area? Any paint or anything that will help prevent any corrosion?

I just installed mine this weekend using some rubber bumpers for the front. My question is that most people seem to have gotten two sizes for spacers but I only got one size. Is that normal? I used 2 extra fender washers for the middle spacers and just torqued the bolts down to close the gap...

Do you have pictures close up and also somewhat zoomed out of the rubber foot? Is the rubber foot very noticeable or does it blend in well?