Recent content by FullTime4

I think something changed in 2020. They're still listed as 315MHz on TPMS.com, but the part numbers are different. My 2021 doesn't seem to like sensors which worked fine on my 2016. :redbrick:

I'd file a police report with the department local to the seller's info in the payment service, IP addresses used on T4R, and area code of the phone number. Also file a complaint with whatever payment service was used.

Doubtful those tires are safe after that amount of time spent in storage - I'd replace them.

I don't think this would affect the automatic high beams since they use the safety sense sensors. However, page 233 does state: Temporarily lowering sensor sensitivity The sensitivity of the sensor can be temporarily lowered. Turn the engine switch off while the following conditions are met...

I just purchased a '21 Limited a couple grand below MSRP. I couldn't refuse the price they offered for my trade-in. :biggrin1: Other dealers were selling for over MSRP, so it definitely depends on your specific situation.

Highly recommend the LFD bars on stock rails. They sit slightly higher than OEM crossbars, but not as high as a Thule/Yakima system. LFD makes a full rack too if you'd rather go that direction. Their craftsmanship and customer service is top notch. LFD Off Road - Ruggedized Crossbar Bundle...

I recently put an iDataStart remote start module in a different vehicle, but it is available for the 4Runner too apparently. Combined with the vehicle-specific T-harness it was almost plug-and-play, only a couple wires to splice. You then use the factory remote to start the vehicle. They also...

I have the Thule Force XT XL on LFD bars (and factory rails) (5th Gen T4R). I'm using the LFD bar with the integrated wind fairing on the front. To mount the Force XT XL with no hatch contact, it needs to be pushed almost entirely forward and carriage bolts (or something else) used to mount on...

With inaccurate information at that.:police:

The best bang for your buck to improve your headlights is to keep a halogen bulb. Check out this comparison: 3rd Gen HID vs LED vs Halogen H11 projector headlights | Tacoma World And more reading about why your LEDs are not helping: Why Most LED Headlight Upgrades Don't Really Work: An...

Have any way to verify that claim? :doh: Here's a pretty scathing review of Boslla LED headlights, which falls in line with pretty much every other LED headlight bulb I've seen tested. Kickstarter Thoughts? | Page 2 | Tacoma World

https://www.top4runners.com/runhist/index.html The limited models add ventilated seats in 2014 if that's your thing. :moon:

I bought mine from RockAuto for $37/ea. after shipping and tax. You can typically find a 5% off coupon code pretty easily. They were Denso brand, which I believe to match OEM.

I don't think my PM to you went through. Send me a message:cheers::cheers:.

Email Husky and request the x-act contour mats for the 5th gen 4Runner!:keyboard: I had to cut the little plastic nibs off the section of the mats that lays on the door trim to get them to lay flatter but yours look pretty good. Perhaps they've improved the underside design as well.