Recent content by gigerunner

Im trying to decide on Doug Throley or Rocky-Road Outfitters 1988-1995 Toyota Truck / 4Runner 3.0L Long Tube Headers (4WD) Toyota Headers: 50 State Legal Toyota Headers Any insites from you guys running them would be appreciated Sent from my SM-G970U using Tapatalk

I have a pair of Old Man Emu CS009r Leaf springs that I cant seem to return. They are 2in lift dual stage leaf, new unused and uninstalled. Fits 1984-1989 t4r/ 1979-19888 pickup. Local pickup only will not ship. But I am willing to drive to meet or drop off if close enough. Old Man Emu Leaf...

Fan pulley assembly is toast also. Back to Napa I go.

I have a little more in common with my runner now. On another note now that I am healed enough to turn a wrench my water pump decided to grenade. I found this on my skip plate. Along with some metal shavings near the pump. I see my Memorial Day weekend is planned for me.

I will check it out tomorrow. thanks for the info

Actually now that I am back at work and was able to get a full tank though it with easy driving my mileage seems to have gone down a little. Im still driving it like miss daisy on the pavement. Perhaps its running a little too lean? I may open up the VAFM and richen it up a couple of clicks.

This old midland is a 40 channel

It will going in the ash tray. I picked up a accessory fuse block the other-day also so I all need it some time. I have the cb, oba and an 750A inverter that needs mounting and wiring. But I'm back to work since I broke my clavicle in December. So now time is scarce.

Picked this up today

A little organizing today. I made a small cabinet for the back. Drawer slides. I thought this was a perfect idea for the handles, I have been making paracord wrapped stuff for a few years. Here's is the mounting hardware I used. Installed the back seats keep the large compartment closed...

There is a fan on the end of the compressor to cool the unit. Its on the motor shaft and runs as long as the comp is running. The tank is 1 gallon at 125psi. The tank fills in about two minutes. I dont fear any over heating unless i try running an air tool. In which case. I would have a larger...

the VAFM is plug and go. After a few days I turned in the Idle air screw 5 turns to lower the the idle from 1000 to 700 rpm. I haven't touched the mixture yet. I was waiting until after i got the pipe done. Then i say the post to go wheeling. I am in the 2nd gen Mafia group i just joined.

With the blower motor and housing removed I discovered a small heater core. Then I located the lines that ran to this rear heater core and jumped them to close the loop. Next I removed the hard lines, there are three fasteners holding them on 10mm deep socket. hard lines were a PITA to...

Last in 13 i did my BJ's all 4 just because mine were toast. I got the duralast life timers..... and need to do them again. This Year I did the steering "soup to nuts" all moog. I will be getting moog BJ's when I do them again. If you are going through the efforts do it all. I slowly bought a...