Recent content by gmyatko

Don't know if anyone still needs info on this or not. I've done it. Right now, I have it back out for a bad bearing. If anyone has a question, nows the time. [email protected]

Napa doesn't make the axle assembly. Once the c-clip makes it to where it needs to go, by "adjusting" it, you are pushing the c-clip into uncaptured airspace. So when it relaxes, it is merely coming back to where it rests on a lip. I replaced my axles, not with Cardones, with someone elses...

xfer case won't come off You ever figure it out?

oil leaking fom top of breather Did you have your case underwater? The oil is only supposed to be a little less than half full in the case. Check out what the breather is supposed to look like from a slide at the toyota parts counter. Then it might make more sense to you. I can't imagine that...

2003 transfer case actuator seal leaking I hope everyone has their answer by now about this actuator leaking. If someone is replacing the actuator, it is to make money. The leak is caused by a 30 cent o-ring. The reason it costs so much to fix is that the transfer case has to taken down, broken...

'03 4runner Transfer case actuator So, I just pulled this thing out. It isn't too hard. I'll try to simplify it here, and this is going by memory; Remove the front & rear yoke grease fittings. Remove the yoke 4 nuts each, knock the driveshafts a bit so the yokes come loose, compress the yoke on...

'03 4runner Transfer case actuator So, I just pulled this thing out. It isn't too hard. I'll try to simplify it here, and this is going by memory; Remove the front & rear yoke grease fittings. Remove the yoke 4 nuts each, knock the driveshafts a bit so the yokes come loose, compress the yoke on...