Recent content by goose17

Thank you for posting this. Mine just came loose today, must be from the AZ heat. How did you secure it? Epoxy?

I know this is from forever ago, but I just bought an '08 with the same issue. I'm reading through the fuses in the manual and I don't even see the fuse for the mirror. Any luck fixing it? Thanks

Hello, I just acquired a 2008 SR5 with the Gray Leather Interior. My interior code is FA12. I am trying to find some matching headrests. Does anyone know if LB12 is the same color from the Limited? I have included a picture of my interior and of the headrests that I found on eBay. The...

This might help too... How to Service a Sealed Toyota Transmission - YouTube

4th Gen 4Runner Frame Rust Update I just spoke with the law firm handling the frame rust suit against Toyota. It goes to trial in November, but they said they are not sure how long it will take. You can go to their website and add your vehicle, here is the link: Do you own a 4th generation...

Just fixed mine today. This is what I posted: I've had this issue on two of my 4th Gens. I fixed both with the heat and neutral hill roll backwards method. Wait for a really hot day and bake your 4Runner in the sun and also drive it around for an hour or so. Once it's nice and warmed up put...

I've fixed this issue twice I've had this issue on two of my 4th Gens. I fixed both with the heat and neutral hill roll backwards method. Wait for a really hot day and bake your 4Runner in the sun and also drive it around for an hour or so. Once it's nice and warmed up put the vehicle in 4WD...

I'm having the same issue I just started having this issue today on my 2008. I took the trim piece off the back where the Toyota emblem is located so that I could plasti dip it. When I put everything back together the lift gate won't fully close and won't open. Everything is back the way it...

Thank you very much for that info!

I have a 2 foot breaker bar and a new DeWalt impact wrench rated with 700 foot pounds of torque and 1,200 foot pounds of breakaway torque. I'm hoping it can make the job a lot easier, but it really depends on the rust.

Cool, thanks. I did watch a YT video where they replaced the lower ball joints on a FJC. They didn't have the right size attachments for their press, so they torched it and hammered it out. It looked like more than I am willing/capable of doing. I will get the big kit and figure it out. I...

It has low miles (101k), but the previous owners did not take good care of it. The CV axle boots are torn on both sides and they are puking grease. I am going to replace them with aftermarket Cardone Heavy Duty axles. It looks like the ball joints are leaking too, so I was going to replace...

Hello, I recently purchased a 2008 with low miles and have been fixing it up. I was planning on replacing the lower ball joints, but I can't find adapters to fit my vehicle. I contacted a manufacturer and they said if they don't have them it's either because you have to replace the control arm...

No problem... Thank you though!

Still don't see it Thanks for the reply, however, I still do not see it.