Recent content by Got2xlr8

Was looking at ML63's and GX's I think the implied reliability is the long bet. I can say without equivocation that its by far the most comfortable ride I've had, It came with Goodyear-SRAs which im not impressed by, looking at Cooper AT3 4S ~September. I've also found that most of the 4R stuff...

Applied today, Joined the 460/470 owners.

Thanks! I had my T4R for 8 years, and hope the GX can repeat or exceed that performance. Pick it up tomorrow. had some minor paint work to clean up before I'd take possession.

Good day to you, Just wanted to extend a forward apology, I as a new (to me) GX owner will, (likely) be cluttering your forum with FNG posts. I have been active in the 4th gen forum over the years, and truly appreciate the tolerance and unending understanding that the members over there have...

+1. was going to pull the trigger on a full exhaust replacement. already have SAIS bypassed.

The Secondary Air Injection System (SAIS) is for smog control, fresh air is injected into the exhaust stream to allow for a fuller combustion of exhaust gases. It is widely regarded as preventive maintenance to disable the system, if permissible.

managed to snag a pic of the module from ebay, looking at it, the switch is likely going to connect to a controller elsewhere, I don't think its feasible to continue.

After waiting 2 weeks for a call back I called them, no movement on pulling the switch or wiring harness. Rep suggested that for his guys to go pull the part they wanted 20% down on the full order. $400 to pull the switch and harness. without knowing it will/wont work. Anyone know somebody...

Called the yard they are including the Controller, and the floor wiring harness. anyone have any idea if there would be any other module/controller behind the dash that would be required?

Thinking of trying to put 5th Gen Vented Leather in my 4th, I have a line on a color matched interior. I have located the part number for the seat temp controller (84752-35010) other than needing a wiring harness, do you think this could work?

I have Morimoto 5K 35w in the low beam, Morimoto 3k 35w in fogs, and VLED 1800lm LED's in the brights (the older ones), the new models look impressive 4500lm on the new mini, and 6000lm on the lmz. have had no issue with the ballasts, LED responds instantly to activation. make sure you do the...

I installed the V3 Tritons both front and rear (Amber only, Kinda wish I had order the switch backs), the Triton kit comes with a built in resistor and works flawlessly with the DRL.

No its Prismatic Powders Kingsport Grey with a gloss clear.

My wheels had started peeling, so had them blasted and powdercoated.