Recent content by harry comes

I just pulled mine out last week. It's real easy. Once you remove the inner trim and plastic gasket trim from around the window, take a utility knife and run it along the inside edge all the way around the window to cut the butyl tape. Then push the windows out from the inside.

Ive got a set of OME springs I'll be putting on this week. Everything else is stock. I'll take some measurements and pics when I'm done. BTW I bought my OME springs through amazon. I think I paid $110 a side and it was free shipping. Everone else wanted $40-$50 for shipping.

Yes, I used Brightside Blue Glo White, 4 coats, light sanding in between coats.. It's got some orange peel in it, but not too bad. I used fiberglass mat to fill in the big holes. I used some metal flat stock in areas to get the body lines close underneath the matting. It was my 1st time using...

Hey everyone. I've been lurking on here for a while and figured it's time to post up and say hi. Ive been a long time Toyota fan ever since I bought my 1990 4x4 pickup brand new in highschool. Since then I've had a 2003 4runner V8 Sport, 2007 FJ, and a 2007 Tundra 5.7 4x4. I've been dying...

intermediate pipe I just bought the Dynomax exhaust for my 88 V6. Is it the stock intermediate pipe that is needed? I tried mounting the exhaust today and with the existing intermediate pipe ( curved) from the cat, I had to put a 1 7/8" sleeve to connect the pipe to the new muffler. The...

I would be in for a 1st gen.