Does anyone have a pcyure of the inside of the rear window switch. I was taking mine aprt to clean the contacts and something (spring?) flew away far far awy. What doe this part look like?
cost of
If you are notdoing the work yourself lots of 4 will be spent on a t4r. New drive axles will $500 installed easy, New brakes can eat up $500 if they replace a lot of stuff. T4r'scan be high maintenance.
spare tire
I had to grind and drill and hammer to get the spare tire out of there. I made up a home made system that uses a long Bolt with a loop on the end that ties into the old box. A nut, plate and spring clip holds the tire up there now
dome light
My dome light does not work and I don't want to fix it. I work alone in the bush and when I get back to the truck I don't need a dead battery cause I left the light on
vibration
If you can jack up the front end one tire ata time and try to move the wheel. If their is play try to determine what is not tight. Could be a tie rod end or wheel bearings. Have someone help as four eyes are better than two.
scraping noise
Check the drive axle boots first. Alao check the stops where thw hub meets the lower control arm, should be an aluminum strip bolted there.
drive axles
When I said play, I mean less than 1/8 inch more like 10-30 thousands of an inch. Did you remove the 4 bolts of each ball joint or split them.
rear window
The most likely culprit is the little nylon wheels that are attached to arms that slide in the tracks attached to the bottom of the window. You may have to replace the piece that is attached to the bottom of the window that the wheels slide in, or replace the wheels (they are...
drive axles
Good luck. I have mine out on two different occasions. I hate to beleager this point but check the dust seals on the back of the hub unit. They may not be seating properly or bent. As mentioned earlier there has to be some play when the clip goes on..