Recent content by hklt4R

The only real way to prevent sway bar from hitting is with the brackets from Sonoran Steel. Longer links will still have you hitting. As far as replacing it’s pretty easy. There’s 2 nuts on the studs for the 3rd member and one 12mm bolt holding it to the housing. Then you just need to undo 2...

Definitely looks like an axle seal leak. I just started working on replacing my 3rd member and found both seals leaking when I pulled the shafts out. I also did not have any leaking from the drums onto the tires and no other signs of leaking externally. Rubber inner parts of the seals look fine...

I got some Morimoto load resistors from theretrofitsource and just installed them on the body right behind and underneath the headlights. You just wire them in parallel with the turn signal wiring and you should be good to go. Will only work for the front tho. If you install led turn signal...

Make sure you check the position of the 4 magnets in the top cap of the motor. Mine were slightly out of place causing the motor to not spin. There’s a good write up on rebuilding that explains how they should be set and glued. Just make sure you note their positions and don’t get them out of...

Just for further clarification, are you saying to put 2nd gen fronts or 2nd gen rears on the front?

So if you download the Toyota enhanced diagnostics do you still need to enter the formula?