Recent content by Hoglegs3006

My rig is a 1999 Limited 4WD 280k miles

I tried to watch your video and it says it's no longer available. Anywho I had a similar issue, I installed OME lift in the front and rear, no issues no creaking noise. I went to have a alignment done and when I left the shop it had a pretty nasty creaking noise coming from the front driver side...

Reviving this old thread. I'm looking to replace the Union Tee fitting that the rear soft line goes to and left and right hard lines go out from that. Would any M10x1.0 break line Tee fitting work? I guess I'm not sure if the end of the soft hose that goes into the Tee has the double flare like...

I sure hope so, I guess only time will tell. I just have to keep a eye on it and hope it doesn't do it again. My biggest concern is damaging some electrical component or it not start while I'm in some remote location in the nation forest. My wife is pregnant and she would be very unhappy...

750 cold cranking amps at 0° F 935 cold cranking amps at 32°F Part number on the battery is 24F-DLG

The battery is a duralast gold from AutoZone and it's about a year 1/2 old. It says it's got 750 cold cranking amps. The terminals are pretty clean but I went ahead and cleaned them up with some rubbing alcohol. All the wires are in fairly good shape too. I don't think the battery is the problem...

Hello, first time starting a thread on here. I have a 99 4runner limited 3.4 automatic trans 4x4 with about 256k miles. I have had the rig for about 6years now and it's always been a great and reliable vehicle. I have gone allot of awesome places in my 4runner. Towards the start of the new...

Very impressive!

Looks pretty good to me, unfortunately mine has some rust around the rear axle. It spent a few years in the Midwest.

I sent a message about ordering a couple decals from you but I'm not sure if it actually sent. Still a new member and haven't made my 15 posts yet.

That could have been very bad. Just curious but any ideas on where you would mount your fire extinguisher inside? I have thought of doing this but never got around to it, I should probably do it soon before wild fire season starts. Better safe then sorry.

I couple days ago I replaced both of the o2 sensors on my 99 limited. Up steam and down stream . Holy cow those nuts were hard to get off. I soaked them with PB blaster for a few days and ended up using a torch to heat them up and a box end extractor wrench to break them free. Talk about a pain...

Those lights looks great! Was that a Amazon purchase or what? I have been looking around for a set of off-road lights but it's a tough choice.

Nice rig! Very clean and I love the color.