Recent content by hoodwink33

Its low on freon. I had the same issue. Added freon and now its resolved.

Added JBA upper control arms Sent from my iPhone using Tapatalk

How ironic..., I was experiencing this today and tried to find the right words to do a search. But yes I'm experiencing it along with feeling like I've lost several horses while running the AC.

Here's a set posted in Charlottesville today: https://charlottesville.craigslist.org/wto/d/trd-pro-black-17-7-wheels/6555356487.html

2014 ultra with fat front conversion Sent from my iPhone using Tapatalk

I tend to drive her like I stole her. Especially since I changed out the exhaust with the Gibson!

following...., I was thinking about the same.

I don't have a dog in this fight but I saw a 97 today with 209K looked great, the person stated its in immaculate condition with complete maintenance records. It's located I'm Petersburg, VA and they are asking 4500 obo. It really looked sharp. I did take a few pictures on if, however I'm...

What part of North Carolina are you located and are the tires included? If so, what is the tread life remaining. Thank you.

Side note: You can get the cats done cheaper than 2500. A set of aftermarket headers will cost less than 1000, and a decent shop should charge well under 1000 to install them. Not sure if the Doug Thorley headers are CARB legal in CA yet since you're in Burbank, but take a look as a set of...

I purchased my '06 in December with 158k miles on it. I didn't hesitate buy it with this many miles on it. Three months in, I feel like I made a great choice and wouldn't hesitate buying another one with equals miles.

The nose dive has been reduce to nearly zero along with the slight body side-to-side roll. I also feel like the bumps are not as prevalent anymore as well. Since I didn't do the springs, I am a little disappointed I didn't get the lift I was expecting. I should have done my homework on that...

I actually did not do the work myself. I recently had rotator cuff surgery and was eager to get it done. But yes the front struts were trimmed with a grinder and the rear mounting holes were reamed out using a 3/4'' drip bit. I'm not sure if there are existing holes in the frame to secure the...

Are your measurement based on from the ground to the fender? Also, you mentioned you had to buy the rear reservoir clamps. My kit came with the clamps included. You might want to follow-up with the vendor and ask why your kit's clamps were missing.

I was thinking the rear was gonna lift another inch, but you are right it was unchanged because I didn't change out the rear springs. I might do it down the road.