Recent content by JAKSON

Tahuya Figured I would just reuse this thread. If anyone would like to run Tahuya we will be meeting at the Safeway in Belfair at 8 am.

I like the stratchits and wolf packs. Can never have too many of those. 10 of these with some 8mm bolts. I use them up top as stops and usually on the underside for tie-downs. https://www.amazon.com/Eowpower-Stainless-Steel-Bolts-Threaded/dp/B06XC84DMT

I just had this happen except it was the front signal. Worked sometimes then hyper flashed. Filament was fine but put new bulb in anyways. When I looked closer at the old bulb I noticed a small crack in the base. Did you replace it when it was out?

I wired up one of those in my 4runner. Are you going to run an aftermarket amp? That will tell you which harness. The 87 and up 10? pin is probably wrong. Now it should be a 28 pin connector. You don't need the SWC kit. It should wire up directly (2 wires). Either way Axxess sells the 6...

The factory 12v outlets are not rated to run that fridge. Thats why people run new wire and outlets. The 110 volt will work but will turn off when ever your 4runner is off. Unless they changed since 2013. You don't need dual batteries to run an outlet for part time use.

Did I miss where you finished a dual? That would be on the really really short list.

No tool just a bolt, nut, and some washers. Impact driver makes it very easy...

I don't think they will work well. The racks have different side profiles and I think channel width. I have the FR brackets and I like them. To me they are worth the extra money to fit right. The only thing is they were kind of a pain to put on and take off because they bolt from the top and...

Yeah I had thought about the cover before this. Funny thing is if I would have just bought it then I would have never known. Anyways the cover is pretty nice and I am happy just wanted to make sure anyone else who may have the problem has a solution. Now back to drawers and slide.

Quick update since I hate it when people don't report back. Cover arrived and put on. Door locks work just fine again.

https://www.amazon.com/dp/B01GEK9YT2/_encoding=UTF8?coliid=I37BVF4YU2TVU3&colid=1PB58MYY14HAJ There is a cover for under $50 and the description say aluminum lined polyester. I will probably order that next week and see if that does the trick.

I think that would block the receiver. I did try some just outside of it. I am sure the interference is from the power supplies used. So smaller pieces will block the source........at least it think so. Sent from my SM-G930V using Tapatalk

Well the foil does stop the interference. Remote works great with just that one piece. Now to figure how to do that but unseen. Sent from my SM-G930V using Tapatalk

I have the WIFI off as I don't use it. Not sure if there is something else to change. I will definitely look at moving the receiver next time I can get in the panel. Thanks for the picture jakerunner. At this point it is just really annoying but doesn't stop me from using. Maybe I will get...

I believe that it is now a subscription service. Used to be one time payment, but now it is $10 for a week pass or $40/year. The one month trial is if you buy their $40 OBDII dongle. Most of the cheaper ones work, but for $40 and a month to make changes it is still cheaper than one visit to...