Recent content by jeremy 4runner

I had the same problem with my 96 a few years ago. I had a starter repair shop put new contacts inside and clean everything inside. Then the following year my friends 99 4runner did the same thing and he had the contacts replaced. I think its a common problem but at least it doesn't cost much to...

I like the rotors man. I put the same ones on my rig several months back along with new pads, they are great and look good too. If anyone is looking for some I went on the web at autoanything.com. and you can call them and get more info.

I had to replace my logic module after I got my 4runner. I think your best bet is to go to uhaul and get a new logic box. They are usually less than $20. If you are comfortable with doing the wiring you can install the box inside behind the back panel and run it thru one of the holes that go...

I JUST DID ALL OF THAT LAST MONTH MY SELF AND IT COST ME $75 FOR EVERYTHING. I SURE GLAD I DID IT MY SELF. I THINK THAT IS REDICULOUS THOUGH.

Well one thing to ask is how old the hoses are and how many miles are on your rig. I usually have got the Prestone flush bottle and drained the antifreeze out in a container to recycle. I like to change my upper and lower hoses every 10 years. I replace my thermostat every time I change the...

I had mine cut out and put in a Dynomax super turbo installed. It was a little over 100 dollars. That was about 5 years ago. It was slightly louder than stock but when you go down the road you dont even hear it. Chances are something broke lose and could be restricting flow. You shouldnt have to...

I think you should be able to find sway bars at any rv or trailer shop. If you are going to have a lot of tongue weight you might want to try doing the air bladder upgrade. I have a 17ft camper and when it was loaded my rear end was almost on the axles. I have been happy with it and it was under...

I replaced my rotors and pads. I got the slotted and drilled ones that are made by power stop. They have different brake pads available from them depending on what you want. I think the company was autoanything.com. The rotors were I think about $120 to maybe 140 each. I did have to bend the...

I had the same problem with mine and it was starting to make a little more noise. I was also worried about water getting inside when I washed the car. I think the seal was either $60 or $80 dollars from the dealer. I also noticed that I had to push the door harder to close it. Its not to hard...

Thats a great looking rig, love the hood scoop. Black is a great color to.:awais:

I asked the dealer about this issue and i thought he told me you would probably use more gas and that the engine would not run that great. I would be interested to hear if anyone has tried and what happened. I know there are 2 O2 sensors before and after the cat.

My antique 76 17ft Nomad. Im in the mountains in Montana with the fam.

There shouldnt be a problem. I have the factory 16x7 rims on mine and I put 265/75/R16 and mine dont rub anywhere. I would also recomend having the tire shop put the weights on the inside only so you dont have to worry about the weights scratching the clear coat off.

Is your fan blowing air when you a still?

I went to a trucking supply place and got a tractor light in a rubber housing that usually comes with a 35 watt flood light. The light housing itself shouldnt be more that $15 each. After that you can change the bulb to whatever kind you want. Note: I have had problems with water staying in the...