Recent content by JerkyDrewster

It was about $50/shock in parts if you do it yourself. I'm guessing a place like Accutune or Shock Service will be $150-200/shock. My build thread in the signature has all the pictures of it over the years with them installed. I sold the UCAs separately, so dropping the price down $1,800.

SOLD Selling a Stage 5 Icon setup for a 3rd gen 4Runner (minus the rear coils). Suspension worked great while it was installed, but I don't need it anymore. Coilovers and shocks have been rebuilt one time, but will need another rebuild probably before installation. Shock shafts are in excellent...

The carpet and seats look awesome! Great job on the sound deadening and other updates too! Have you put any deadening in the cargo area or just the main cabin and doors?

Bump. These are still available.

I think you might have me confused with someone else! I think the most I did to my AC system was a standard recharge. My wife's old Civic had 3 compressors replaced in 2 years though... :frusty:

I ended up with the 650# springs from Icon. I think the combination of the 3 ply tire sidewall and the heavier spring made the ride uncomfortable. I also don't have as much weight in the front that these springs probably need.

Selling a set of nearly brand new 14" x 700LB springs for Icon 2.5" coilovers (Icon PN 158508). I used them for about a week, but ended up going with a different spring. Springs are in great condition and have maybe 100 miles on them. Some slight cosmetic damage to the powder coat from the...

Fender Clearance Needed to trim the fenders back quite a bit since they were rubbing at the side closest to the doors. Instead of cutting exactly what I needed, I figured a mostly even cut all the way around would look better. Overall, pretty happy with the results, but still not sure what to...

Thanks man! I left that one still connected mostly because it was a pain to remove. I'm sure some current flows through that cable still, but the 4ga wire would have less resistance than the stock wiring. So far it hasn't been an issue! That's an impressive amount of miles on those tires. I...

January, 2022 35's and Firewall Tub! Parts List: - 315/75r16 Falken Wildpeak AT3W - 2'x2' 20ga steel sheet - 2x 4' L x 1/8" D steel rod - Seam sealer - 3M Rubber Undercoating - Some sound deadening Tools List: - MIG Welder - Sheet Metal Nibbler - A bunch of cutting tools - Angle...

November & December, 2021 Hood Struts and New Fuse Block Bracket Parts List: - Spiker Engineering Hood Struts - Modified Ripcord's Fuse Block Bracket A couple of small projects I finished at the end of the year. The hood struts have been on my list of nice to have things, and saw that they...

Thanks for the kind words! I started out not knowing much and just learned as I went. This forum and others have a ton of useful information to get you going!

Thanks for making great stuff! That's pretty cool about the curved slot. If I had a lower profile hood, I think I would have gone for it instead of the rear, but I couldn't get a good angle to see it.

November 20, 2021 Strut Tower Reinforcement Parts List: - Eimkeith Strut Tower Reinforcements I've had these parts for a couple of years now, and wanted to finally get them installed. I borrowed my friends tig welder, and after practicing with it for a few weeks, I decided to go to town. I...

I initially had my sliders right under the body and it contacted the pinch weld when the body would flex. I just put a 1" body lift on and it seems perfect. I was worried they would be too far underneath, but I am pretty happy with where they are located!