Recent content by jgravlin

I drove the vehicle for a while and finally got it to throw codes for cylinder 1 and 6. As crazy as it sounds both coils went bad at the same time. I replaced them and all is good now thanks for all the suggestions. Sent from my iPhone using Tapatalk

This issue started on a trip in the mountains misfires from a complete stop at low rpm, but above 2300 rpms the engine is strong and no misfires. I have codes P0300, P0302, P0303. Had to drive it home 2 hours it would only misfire below 2300 rpm more so around 2000 rpm intermittently. When I...

They can be a bear. You will need to soak the 6 studs and nuts also the 2 studs between the y pipe and the cat, and the 1 mounting bracket bolt holding the exhaust with penetrating lube for a couple days before you try and take it apart. Sometimes they come loose. Just go slow tighten and...

I got to the manifold a day early all 6 studs came loose from the block which I am fine with. The 2 studs on the lower connection point also came loose easy peezy. The hanger bolt did not come free, I sprayed more penetrating oil on it if it does not come loose I am going to just cut it off. I...

I am getting ready to start removing the passenger side exhaust manifold on Friday. Mine is badly cracked and getting worse. I have been soaking the bolts and nuts with penetrating lubricant for a couple days. I don't live in the rust belt but the nuts look nice and rusted I will let ya'll...

CrikeyMike could you help me out on this? IMS59-50220 with C59-314 front I am good on this setup. I want about 2 1/2 inches in the rear. Could I put the C59-675V with the IMS59-50701 and be able to accomplish this? On my 2020 4runner I have the IMS59-50701 with the C59-325 but that's...

I went ahead and added the 1/2 spacer above the rear driver side coil and I am 1/2" different in the rear now. 24 1/2" Driver side rear IMS59-50701 C59-325 25" Passenger side rear IMS59-50701 C59-325 23 1/2" Driver side front IMS59-50700 C59-314 23 3/4" passenger...

I don’t have kdss. Coils have about 350 miles on them at this point. There was a 1/2” lean to the drivers side before the lift. Sent from my iPhone using Tapatalk

Dobinsons 5th Gen T4R Suspension options - lots of choices I installed my dobinsons c59-325 coils in the rear but I am getting 24” from center of hub cap to fender on drivers side rear which is 2 inches of lift and 25” on the passenger rear which is 3”. Not sure what’s going on both coils had...

With the IMS59-50700 with the C59-314 front and the IMS59-50701 with the C59-325 my question is will I need a sway bar relocation kit and a diff drop kit?

Question for you crikeymike I just ordered the IMS59-50700 with the C59-314 front and the IMS59-50701 with the C59-325 my question is should I have went with the C59-327 rear I have a 3/4 roof rack and rock sliders and I have a RTT but I do pull it off for periods of time. I have the rear loaded...

I have the 3/4 rack and love it. I just wish I would have went with the full rack now that it’s on the vehicle and I have seen a full rack on a runner Sent from my iPhone using Tapatalk