Recent content by Jimbo03T4R

I've been off for a while but it's time to continue with the build. First thing, is anyone from the forum located in San Antonio, TX? I've moved from Augusta to San Antonio and would like to get some information on the area and places to visit. Thanks. I have to come up with a new list of...

Sorry, I haven't been on in a while. I assume by now, you got the information you were looking for. Let me know if you have any questions still. Thanks.

I haven't done too much since my lift and tires but I did add this little gem to my truck.

Finally got my tires installed and my alignment as well. I'm finally completely finished with the lift/tires portion of my build. I also added some more sticker to my roof rack. Next I will be working on plasti dipping my wheels black, adding an emblem to my grille, and working on a few minor...

I received the daystar spacer from clark_12 today and got it installed. My runner is now mostly level. I have an empty tank and the rear is completely level and the front passenger is less than 1/4 in higher but it's not really noticeable. The company I ordered my tires from sent the wrong...

Cool. Thanks for the info.

Nice setup. Where did you order the gobi ladder from? That's pretty fast shipping compared to the websites I've seen it on.

I'm looking to buy a steelcraft bullbar for a 4th gen 4runner.

Thanks for the info. 1.5" did seem like a lot but I just measured the disparity and it's a little less than an inch and I have an empty tank so I can imagine how much weight a full tank will be.

Do you all think this will work? Amazon.com: Daystar KG09103BK Comfort Ride 0.75" Rear Coil Spring Spacer Kit: Automotive

I need to get a spacer for the rear driver side to level out the 4runner after the lift. Which one should I get?

I finally finished my lift. I removed the xreas and ras and installed 5100s all around, 885s in the front, and super flex's in the rear. I have to go get an alignment but it's not too bad right now (pulls slightly to the left). I drove around the neighborhood and it's definitely much better...

It'll fit with some trimming. You have to trim the actual grille and the metal interior bracket. Right now I don't have the secondary hood release but I plan on putting in back on. I also had to trim the black piece (when you open the hood, it's the piece against the bumper and between the...

I think I got it. I just needed to apply a little pressure on the uca and i have everything connected now

So the pictures that show the 5100/885s are at the point where it will lift the LCA and start lifting the 4runner as well. When I drop the 5100 to the lowest setting, I can push down on the ball joint and it'll connect with the LCA but at the .85, I feel like I would have to apply to much...