Recent content by jjbodean

  1. J

    Rear spring spacer not seating properly

    well, talked to Dobinson's and they suggest getting a spring compressor and compressing the rear spring to get it in position and then slowly releasing compression into the bottom of the spacer, and not doing it by jacking the pass side of the axle.
  2. J

    Rear spring spacer not seating properly

    Trying to install the 1/2" rear spring spacer from Dobinson's on top of my driver's side rear spring, but having an issue getting them to seat together. Spacer is oriented properly with raised area in the center of the spacer down. I'm attempting to jack the passenger's side to get the...
  3. J

    Drivers Side “A” Pillar Grip Handle Installed on 2014 -2025 T4R

    hi jason, i've been trying to get in touch with you, sent emails on 6/2 and 6/12. please reply when you can, thank you, jeff
  4. J

    Evaporator replacement time

    So, just completed the evaporator core replacement, also did the expansion valve and condenser dryer at the same time. I was going to do the heater core but there was a delay in shipping, went ahead and got started on the job and found the heater core to look like nearly new, master Lexus tech I...
  5. J

    Evaporator replacement time

    2007 Sport V6 4WD. 225k miles. A/C went out over the winter. After 3 trips to local shop and 2 to dealer it's been determined that the evaporator is bad, which is what I feared the most. Expecting an estimate of $1200-ish I was shocked when the dealer quoted me nearly $3300. So, I've been...
  6. J

    New TRD Style Grille

    2002-2005 Auto Parts Front Grille With Light Fit For Toyota 4runner - Buy 2002 4runner Grille,2005 4runner Front Grile,2003 Front Grille For 4runner Product on Alibaba.com
  7. J

    FS: 2010 - 2013 OEM 17” Toyota 4Runner Wheels (5th Gen) $200 Portland, Ore.

    resent PM, not sure if it went through the first time, thanks
  8. J

    Replacing rear liftgate / hatch question

    Yes, it's one off a salvage 2003 that's complete, I just basically had to swap out the lock cylinders and I'm good to go. 1. So I dont need to drop the cargo area dome light or remove any of the fasteners to access the wiring harness? 2. I was referring not to the gas support struts but to...
  9. J

    Replacing rear liftgate / hatch question

    A couple questions before tackling this hatch swap: 1. What is the easiest way to access the wiring harness inside the headliner? Is it necessary to drop the headliner in the rear or is there a more efficient way? 2. Is it best to leave the existing hinges on the body and replace the hatch or...
  10. J

    Adding a Console USB Power Port to my 2007 Sport

    i just installed the mictuning port in my 2007. using a fast charge usb cable connected to the port gives me the same charge speed as when connected to my fast charge wall charger. device being charged is a samsung galaxy s7 edge. when charging using an older cable connected to my grom audio usb...

Members online

No members online now.

Forum statistics

Threads
278,309
Messages
3,554,070
Members
248,016
Latest member
Advally Service
Back
Top