Recent content by jluu6r

yes, after pumping the brakes 20 times and holding the brake pedal the pedal starts to drop slowly. They are working though, just feeling mushy. I didn't remove the master cylinder cover when I compressed the caliper on first side (driver side). Could that have messed something up?

It’s a 2000 SR5. I tried pumping the brakes, first with the truck on then with the truck off. Unfortunately no luck. Still getting a hissing sound from the back of the brake booster when I press and hold the brake with the truck is on.

This was my 1st brake job i've ever done. I replaced my rotors and pads. Didn't open the bleeder valve and compressed the caliper piston while making sure the master cylinder didn't over flow, I did have to remove some brake fluid. I started my truck up and press the brakes and it's feeling...

I believe the front brake lines are off a tacoma. Here is a video I found. YouTube Stoptech part #950.44014 Wheelers offroad part #TF BLINE-07

you will need a dash kit, unless you buy a double din head unit and get a wiring harness so all you have to do is match the wire colors. then all you need to do is plug it in.

i thought i wasnt doing so great getting 250 miles on a full tank (14-15 gallons) stock. After i did a 2" lift and 17" tundra wheels im now getting 230 miles on a full tank.

that's terrible. if you didn't have full coverage, hopefully you had uninsured motorist coverage. that coverage would cover your vehicle and your bodily injury and even pay for a rental car.

i'm in the same boat as you with the 881/906 combo. i bought everything from wheelers and their website says the 881 provides 1.5″-1.75″ lift and the 906 provide approx 2" of lift for a 4runner. my front is 36 1/2 inches and my rear is 37 inches (measuring from the middle of the wheel, from the...

I just had new 881/906 springs installed and the front is a 1/2 inch lower than the back.

I was looking at that setup also because its so cheap, but from what ive read on this forum the spring sag quickly and the shocks wont last long.

i think grill guards look good. maybe replace the front driver side bumper flare. change the hood to one with a scoop.

thanks for the info fellas.

It's the plastic trim

my front passenger seat side cover keeps popping off when a passenger slides off the seat to get out. anyone else have that problem? is there a fix?