Ok so the volts were at 14.7 the entire time. To answer that. So the solution was the new battery terminal connector on the negative side wasn't clamping down enough so I had to flip the clamp end over and throw some grease on it. This caused the melting of the fuse box and the two fuses next to...
So the melted wire goes from the fuse panel into the wiring harness pack that runs into the lower part of the engine,the fuses next to the wire were melted as well. With this wire connected the negative on the battery causes clicking noises when touched from ground using a light gauge.ill try...
Hello and thanks in advance, I removed my console and the center over to place my CB in the dash instead of on the floor. The CB has been wired in for a month and had no issues. This am I went to start the vehicle and the alarm was acting funny and wouldn't allow me to start it. I finally got...
So I had this happen and it has to do with your loop, opening and closing. I found a few different answers a durks link said, but I tried everything before replacing anything big and it went away.
So I know that this is a super open ended question, but it's been getting worse lately and if you roll the back window down its worse. Any advise on where to begin checking or what part of the exhaust may be causing this?
Thanks in advance,
Josh
Well it probably would have if I didn't put the lift on. I think it gained about 4 mpg after replaced. I was getting like 140 miles a tank. Now I get closer to 200-235.
171
Have you replaced your O2 sensor recently? I had the same issue, guy before me replaced it with a cheap sensor and it didn't read properly. I put an OEM in from the dealership and I haven't ran into an issue since.
Post terminal came off my truck the other day and had no issues with the engine or transmission kinda sputtered from the voltage influx but ran fine. Besides that have you had a auto parts place check the voltage?