Recent content by Jordan River

So im having a tough time finding the spark plug wires for my 2000 3rz 4cyl. I have no distributor? They plug directly to my Ignition Coil and I see the wires all come together inside a plastic heat shield casing, and appers to run over into my passenger side glove box. I'm getting a P0300 and...

Bump.

I mean honestly for the price it's worth a shot on the insulators. I have a hanger on the last(2nd cat) that is towards the rear. My first cat has no hangers on it at all. So maybe I should have one on that Cat? So you had to weld new hangers to the vehicle and cat/muffler/exhaust? I'm...

Yes. The end of the tailpipe vibrates the most, moving back towards the engine- the muffler i can see vibrating, the two catalytic converters I have vibrate a decent amount. I have a total of 4 insulators- 1 near the end of the tailpipe, 2 on the muffler, and one on the 2nd catalytic converter...

Would changing these Black Rubber Insulators on the exhaust hangers help stop vibration or droop? I have a vibration on the exhaust when in gear either drive or reverse. I can put my foot on it, and it will stop making noise from the vibration.

Not sure if it's worth it or not. I don't seem to have any troubles with it, almost a year later. I just don't get why the 1.8 kw wasn't even an option. I'm in Florida but didn't think location would change much.

So did you wind up replacing the front(Sway bar) and rear suspension stabilizer bar? Or did you only replace the bushings inside the bar?

I was looking into this post and another one about Kilowatts before recently replacing my starter. I have a 2000 3RZ-FE 4 cylinder Base 2wd. I thought I would need to remove my sway bar as most people stated from removing from the bottom. No sway bar removal or even my skid plates(Which would...