Recent content by joseivan

2011 4 Runner Mud Guards I just installed the original OEM mud guard to a 4runner with running boards. If you have to instal the Mud guard you just need to slide 3 inches to the back the running board. Just losse 6 nuts that hold the running board to the base. That it, I will post photos in...

2011 4Runner Mud Guard with OEM Running Boards Hi: To install this mud guards, Do you move the running board a little bit to the back? Regards José I. Beauchamp

Hi: Do you have the part number of these mud guards? I got the oem running boards, so I need the mud/splash guards. Thanks José

Brake issues Hi: Today i felt something different when I was braking. I was running in an asphalt road that have a by level, just in the moment when I crossing from the soft pave to the rough I brake an I heard the grinding noise. But I try to reproduced again and nothings happens.

Installing 2011 4Runner Exhaust tip Hi: I Got the instructions. There is an internal bump inside the tip at the bottom. You should touch with the exhaust inferior part. The clamp nut should be at 10:00 position left driver side. anything else is correct. Installation. (a) Make sure...

Thanks for your instructions, were very helpful. In my case I used a small laundry clip to open the end caps. Because have the perfect form to introduce it below the edge and with a small pressure the cap was released. Thanks