Recent content by Js'00imited4runner

Yeah I actually do! Sorry for the super late reply. If your no longer interested I understand!

Ugh haven't been on in awhile! Still have a lot of these available!

I'm not completely sure about your question..I was just putting this out there because their hadn't been any alternatives to checking fuel pressure besides the specialized union bolt for the fuel rail. I ended up dropping the tank and putting in a new fuel pump and it solved my issue with the...

Yearly DIY thread bump!

I went to a local pick and pull and cut the soft line fuel fittings inside the engine bay then disconnected them and just ran a piece of hose with hide clamps and you use that to extend your fuel lines and just add a pressure gauge with a T fitting. I haven't been on here in forever...man does...

Only issue with this is the airbag. I pulled one out of a camry and everything hooked up but the airbag was slightly different sized. So make sure you take everything and swap it all out. Good luck with the search!

Too add to it the frame/underneath doesn't look up to snuff enough to be asking $30+k..No thanks. Their trying to bank off the 3rd gen nostalgia.

one year anniversary bump.

anniversary bump.

It will work but only with the camry airbag as well. I actually have a camry steering wheel that I was gonna swap but never had the chance to go back for the airbag. If you are interested let me know. If not good luck on your search!!

What about a pair of vise grips and a long pipe? Then it won't slip off as you pry up on it. Or a prybar/solid piece of steel inside the hole and pull up on the hole? Probably wanna put a lot of heat to it first.

I got the headlights, projectors, HID bulbs and HID controller all for less then $100. DIY cheap and easy HID projector retrofit Here's what I followed. I'm a little thrown off my your comment. Are you recommending diy? or disregarding it due to more available options of aftermarket projector...

Go to a junkyard and get a set of OEM 99+ headlight housings and either install them with higher output halogen bulbs or attempt to make your own HID retrofits. I have a extra set of 99+ housings I pulled from the junkyard incase I screwed up at the HID retrofit. they were $20 a headlight. A...

I would definitely change that ASAP. Before you know it you'll forget about it until it leaves you stranded. I did mine at 203k and I couldn't believe I waited that long. Pretty sure it was original. Always good to have peace of mind that its done and you don't have to worry about it for awhile...

DIY repair thread bump.