Recent content by k_marshall

I have eibach and T1 and T12. T1 at bottom perch and driver 1/4 lean spacer gave me an even 2.5~2.75 inches. T12 initially was at 2.75 driver and 2.85 passenger. I think you would need T12, as if you load your rear you still have some acceptable rake. Bothpics have some just about 120 lbs of...

I have T12 on 07 v6 for about 1000 or so miles. Settled at 2.5 to 2.75inches. Site says the spring rate is 12% increase. My stock rear coil spring rate is 180lb/in.

Did you mark the front and rear U joint? If so, that might help to align. Or you can use the zerks as reference as they all fall in straight line. I just removed my driveshaft a couple of days ago, so i noticed that the zerks are in straight line. I also marked, just in case. btw, misaligned...

I did this setup a month ago. Just that I used T1/T12 instead of eibach coils. I also did a diff drop just in case. My CV looks nice and straight now with my 2.25-2.5"(after settle) lift in front on my 07 v6 4x4. And yeah, be careful of front ABS line if you are planning to unbolt the UCA ball...

Since yours being v8 and not v6, your front might settle down at about ~2 inches(21 inches hub center to fender), so with that I feel .75-1 inch rear height should be at level. Yeah plan for your rear spacer after your suspension settles down. And again, your front driver might need a quarter...

I used wheelers T12. This gave me about 2.75 to 3 inches(unloaded) in the rear on my 07 v6 . Just installed my kit (eibach shocks/struts with wheelers T1 and T12 springs). Lol, now i feel the rear is too high. I still haven't loaded my rear to see how much it comes down though. Have about 100...

Your rake looks level. Which OME rear and how much inch did you gain at the rear?

Doesn't look like it spent 12 years in midwest. Frame is really good.

I followed your thread. Did the similar setup. used eibach shoks instead of bilstein. Gained about 3.5 to 3.75 in the front. My only issue is stock uca is hitting the coils at full droop. Do you also have the same issue? Thinking of ordering SPC or JBA. But wondering if that would solve the uca...