Recent content by klk87

Shawn and I have come to an agreement so marking this as sold.

Ordered these 2 years ago and then life took a drastically different turn. These have been sitting in the garage in my parents' house, unopened. Now I'm selling my 4Runner and have no need for these. Hoping to recoup ~60% of my original cost. I will be in the Bay Area the week of Dec 13-17. You...

Sorry for not replying, been in the process of moving so computer time limited. Did you get your brackets figured out? I can snap a couple of pictures tomorrow if you could still use them. I remember Accutune told me that without spacers the tires would rub on the reservoirs, so I installed...

Sorry, I'm not sure. If you'd like to come by and compare it to what's on your rig to get an idea if it will work, that is fine

Hmm, not sure what's going on with the pic, it loads for me. Here's a direct link, does it work?

Took it off with about 12K miles on the truck. Complete suspension in great condition - UCAs, Front coilovers, Rear springs and shocks.

Did you install the Fox 2.5s? I think we have the same setup so would like to hear where you ended up if you have the numbers.

Almost done installing my new shocks and noticed the reservoir hose was contacting the KDSS hardline on the driver side. No matter how I push or pull the hose or the hardline they still touch. Also, the metal hose fitting coming out of the reservoir is touching the frame. I'm worried about...

I was able to re-tap the threads in the mount to a 14mm. The only 14mm tap I could find at the store was a 1.25 thread pitch, so I went with it but unfortunately I think it was a poor choice as it's very hard to find any bolts for it. Ended up using this as a replacement bolt...

Thanks for all the replies. Yeah I definitely don't like option 3 either, I am going to try option 1 today. I looked up the drill size required for tapping a 1/2" thread and it looks like it's 29/64" or 11.5 mm which I don't think is large enough to clear out the existing threads. So I think...

While installing some new shocks I stripped the threads inside the bottom mount on the driver side. :bash: It's pretty bad, the bolt barely catches any threads I can almost pull it in and out without much trouble. I was thinking of 3 ways to proceed: 1. Retap the hole with a larger thread...

Yes, they are.

To anyone browsing this zombie thread, this site helped me a lot for installation with KDSS: https://trail4runner.com/2017/11/20/rci-rock-sliders-install-5th-gen-4runner/ It was definitely a bit more work than I expected, mostly because I was too cheap to get jack stands

What tint % is this? Looks dope Sent from my Pixel 2 using Tapatalk

Have an OEM rack + cross bars available that I removed from my 2018 TRD ORP. Was going to post it on Craigslist but would prefer to help out one of the fine folks on here instead. Sent from my Pixel 2 using Tapatalk