Recent content by kvincef

Its fine with 3people easy with 4. once you get the front on the rack it just slides the rest of the way and you can move it around side to side/front to back easily after that

prinsu sells tent risers that lift the tent up off the rails this will also fix the rattling/clunking issues you'll get as well.

never could get a solid answer on heights so i went a different route and got a rhino rack platform instead, which you can easily fit a skybox on. i found this info if it helps. Side Rail Height: 2" (measured at the center) Height Added: 1.75" (measured from the center point of the roof)...

4-3/8" strut nuts 4-3/8" x 1.25" bolts 4-3/8" washer 4-rubber washers (optional) drill 4holes where they land on the rack channels and bolt them down. super easy

it doesn't need welding. Mine had zero fitment issues. for the price its and ok system.

i used to remove the resevoirs to regrease but i discovered i was able to loosen the UCA bolt without removing the resevoirs. standard offset Box end wrench fits. I loosen the KDSS line bracket and push it out of the way to give more space as well.

my icon reservoirs had to be mounted using the non-existant threaded swaybar mounts. the holes for the sway bar mount are there but they are just holes, no threads. I drilled them out abit bigger and used rivnuts. you also have to cut off a bracket covering the KDSS lines on one side, not a...

is that not how the c4 lo-pro mounts as well? found these in the install instructions

OME 150PR10 10mm Rear Trim Packer, 03+ 4runner, 07+ FJ

i had this setup and had definite reverse rake. i had put in 2 OME trim packers on each side in the rear to get it level. this was how it sat after.

1.25"

i think it got corrupted. i just re-downloaded and unzipped again. all good! :hatsoff:

i can't get it to open bluebeam or acrobat am i missing something here? lol

this is bang on. so much relies on the alignment tech. try and find a good shop i asked for "as much caster as you can get" when i first got my lift and alignment done.. they didn't touch it. just did a toe and go.

how much lift are you going after? i drove mine for a year after lifting 3". My caster was somethhing like 0.5-1* camber/toe was in spec. It wandered abit on the hwy every now and then but i wouldn't say it "ruined" the ride quality at all. I did a 4000km road trip that year too. just try...