Recent content by kwhoadley

Any recommended websites? I think I found a YouTube video with the noise. Break pad not manufactured correctly and moving in slide. Going to check it out today. Thank you for the reply and assistance.

Can anyone identify this sound at 17 sec mark? Started after replacing toyotec upper/ OEM lower control arms, powerstop calipers and store brand rotors, bluepit bearings, and OEM cv axles on both sides. IÂ’ve had two alignments since. Double checked all torque specs. I took wheel off and...

I’ve got this on my list for next weekend I think. I’ll have to look around the forum for a write up.

The maintenance continues…. Purchased my 4th 4Runner a few weeks ago after returning from Germany. Before today, I’ve done the following: oil, front and rear diff drain and fill, trans drain and fill, transfer case drain and fill, spark plugs, MAF cleaned Today’s maintenance included: inner...

Thanks inscarguy. PCV is waiting at the dealer for me to pick up, just haven’t had time. Good call on the Toyota website. My buddy said the same thing about vacuum lines, so I’ll be checking those for a third time. Going to be real upset with myself if I missed one of them twice. I’ve been...

Greetings team. Long time member, 4th 4Runner (1997, 2004, 2017, 2007). Just purchased the below a few weeks ago. All maintenance below was done to get a baseline. I’m not new to working on vehicles, but am by no means an expert. Vehicle: 2007 4.7 4wd 146000 miles Maintenance this past...

Bilsteins all around, .85 up front

Hey guys! Hope all is well for you and your families. About to pull the trigger on Bilstein 5100's with the intent on installing next weekend. I am in the Army and will be getting a 4 day weekend. I have read through the write ups on install with Kdss. Im about 80% comfortable with the install...

Dealer round 4... Scheduled to test drive my 4Runner with the shop manager tomorrow morning. This will have been my 4th time to a dealer for the same problem. Shimmy felt in sweating wheel, but more pronounced in the floor board. Its done it since day 1 of purchase, 2018 ORP. Hoping they will...

The dealer was Fred Anderson in Sanford, NC. The staff was super friendly. I don’t even mind that it took 3 hours. What really bothers me is he assured me everything was good while shaking my hand. I would have preferred them come right out and say they ran out of time and couldn’t get it fixed...

Purchased a 2018 ORP last weekend. After a couple days of driving I noticed the alignment and balance were off a little. Had an appointment today to get both taken care of. Drove an hour to a dealer that carried the same "owner name" as where I purchased. Waited 3 hours... Not ideal but if the...

The cargo tray has a locking lever. You should have no problems with them entering and exiting the rear.

Haha, yea thats where I got it! Picked it up 930 Saturday morning. I was going back forth with them all week via email over the price.

Haha yea they came down another $500 on the OTDP. Couldn’t find anyone within 2-300 miles that he what I was looking for and could beat the price. Life’s to short to be unhappy!

2018 orp Picked her up this morning!!! Couldn’t be happier! Finally ditched the 2014 Grand Cherokee. As much as I love all the creature comforts the reliability was becoming questionable. $19.5 OTD after my trade. KDSS, Sunroof, predator steps, and rubber floor mats included. Mods will come at...